Cisco Systems 3020 warranty

Page 11

Using Express Setup to Assign a VLAN 1 IP Address to the Switch Module

Use these steps to assign an IP address to the VLAN 1 interface through Express Setup. You must start these steps immediately after you have installed the switch module (see the “Installing the Switch Module in the Blade Server” section on page 6).

Note If approximately 2 minutes pass after you press the Mode button, obtaining the VLAN 1 IP address through Express Setup is no longer possible unless you remove and then re-install the switch module.

To prepare the switch module:

Step 1 Verify that no devices are connected to the switch module, because during Express Setup, the switch module acts as a DHCP server. If your PC has a static IP address, before you begin you should change your PC settings to temporarily use DHCP.

As the switch module powers on, it begins the power-on self-test (POST), a series of tests that runs automatically to ensure that the switch module functions properly.

Step 2 Wait for the switch module to complete POST. It might take several minutes for the switch module to complete POST.

Step 3 Verify that POST has completed by confirming that the system and status LEDs remain green.

If the switch module fails POST, the system LED turns amber. If the POST fails, see the “In Case of Difficulty” section on page 21 to determine a course of action. POST errors are usually fatal. Call Cisco Systems immediately if your switch module fails POST.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Including License and Warranty Taking Out What You Need IntroductionUID1 LED Cisco Gigabit Ethernet Switch Module DescriptionPort Description Rear View of the Blade Server HP c-Class BladeSystem ArchitectureThis equipment. Statement Installing the Switch Module in the Blade ServerLever for the interconnect module blank Switch module release latch Switch Module IP Addresses Running Express SetupInformation You Need to Run Express Setup Page CBS 153144 Page Page Page Completing the Express Setup Fields Page Refreshing the PC IP Address Managing the Switch ModuleUsing the Device Manager Command-Line Interface Other Management Options Onboard Administrator Command-Line InterfaceCase of Difficulty Troubleshooting Express Setup Accessing Help Online Resetting the Switch ModuleFor More Information Product Documentation DVD Ordering Documentation Obtaining DocumentationCisco.com Cisco Product Security Overview Documentation FeedbackReporting Security Problems in Cisco Products Cisco Technical Support & Documentation Website Submitting a Service RequestObtaining Technical Assistance Obtaining Additional Publications and Information Definitions of Service Request SeverityPage Cisco 90-Day Limited Hardware Warranty Terms Hardware Warranty TermsReplacement, Repair, or Refund Policy for Hardware HP Hardware Warranty TermsDocument Page Page USA
Top Page Image Contents