The Express Setup page appears.
Step 8 Go to “Completing the Express Setup Fields” section on page 17 to finish setting up the switch module using the Express Setup screen of the Device Manager.
Completing the Express Setup Fields
Follow these steps to finish setting up the switch module:
Step 1 Enter this information in the Network Settings fields:
–In the Management Interface (VLAN ID) field, the default is 1. Enter a new VLAN ID only if you want to change the management interface through which you manage the switch module and to which you assign IP information. The VLAN ID range is 1 to 1001.
–In the IP Address field, enter the IP address of the switch module. In the IP Subnet Mask field, click the
–In the Default Gateway field, enter the IP address for the default gateway (router).
–Enter your password in the Switch Password field. The password can be from 1 to 25 alphanumeric characters, can start with a number, is case sensitive, allows embedded spaces, but does not allow spaces at the beginning or end. In the Confirm Switch Password field, enter your password again.
17