Cisco Systems 3020 warranty Information You Need to Run Express Setup

Page 10

Before you run Express Setup, you must set up your switch module to communicate with a Hyperterminal program.

Note The initial configuration assumes that the switch module was never configured, that it is in the same state as when it was received, and that it is not configured with a default username and password.

Note To set up the switch module by using the command-line interface (CLI), see the switch module hardware installation guide on cisco.com.

Information You Need to Run Express Setup

You need this information about your switch module from your system administrator before you complete the setup program:

•Fixed IP address

•Subnet mask (IP netmask)

•Default gateway IP address

You can also configure these optional parameters through the Express Setup program:

•Local access password

•Telnet access password

•Names of the SNMP read and write community strings if you are going to use a network-management program like CiscoWorks.

•Host name, system contact, and system location

When you first set up the switch module, you can use Express Setup to enter the initial IP information. Doing this enables the switch module to connect to local routers and the Internet. You can then access the switch module through the IP address for further configuration.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Including License and Warranty Introduction Taking Out What You NeedCisco Gigabit Ethernet Switch Module Description UID1 LEDPort Description HP c-Class BladeSystem Architecture Rear View of the Blade ServerInstalling the Switch Module in the Blade Server This equipment. StatementLever for the interconnect module blank Switch module release latch Running Express Setup Switch Module IP AddressesInformation You Need to Run Express Setup Page CBS 153144 Page Page Page Completing the Express Setup Fields Page Using the Device Manager Managing the Switch ModuleRefreshing the PC IP Address Command-Line Interface Case of Difficulty Onboard Administrator Command-Line InterfaceOther Management Options Troubleshooting Express Setup Resetting the Switch Module Accessing Help OnlineFor More Information Cisco.com Obtaining DocumentationProduct Documentation DVD Ordering Documentation Documentation Feedback Cisco Product Security OverviewReporting Security Problems in Cisco Products Obtaining Technical Assistance Submitting a Service RequestCisco Technical Support & Documentation Website Definitions of Service Request Severity Obtaining Additional Publications and InformationPage Hardware Warranty Terms Cisco 90-Day Limited Hardware Warranty TermsHP Hardware Warranty Terms Replacement, Repair, or Refund Policy for HardwareDocument Page Page USA
Top Page Image Contents