Cisco Systems 3020 warranty Troubleshooting Express Setup

Page 22

Troubleshooting Express Setup

If Express Setup does not run, or if the Express Setup page does not appear in your browser:

•Did you verify that POST successfully ran before starting Express Setup?

•Did you press the Mode button while the switch module was still running POST?

If not, make sure that only the SYST and STAT LEDs are green before pressing the Mode button to enter the Express Setup mode.

If yes, wait until POST completes. Power cycle the switch module. Wait until POST completes. Confirm that the SYST and STAT LEDs are green. Press the Mode button to enter Express Setup mode.

•Did the switch module not power up?

The switch module is controlled by the Onboard Administrator. If the switch module does not power up, see the blade server documentation for more information.

•Did you try to continue without confirming that the switch module was in Express Setup mode?

•Does your PC have a static IP address?

Verify that all LEDs next to the Mode button are green. If necessary, press the Mode button to enter Express Setup mode.

If yes, before connecting to the switch module, change your PC settings to temporarily use DHCP.

•Did you connect a crossover cable instead of a straight-through Ethernet cable between a switch module port and the Ethernet port of the PC?

•Did you connect the Ethernet cable to the console port instead of to an Ethernet port on the switch module?

If yes, connect a straight-through cable to an Ethernet port on the switch module and the PC. Wait 30 seconds before you enter 10.0.0.1 in the browser.

If yes, disconnect the cable from the console port. Then connect the cable to an Ethernet port on the switch module and the PC. Wait 30 seconds before you enter 10.0.0.1 in the browser.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Including License and Warranty Introduction Taking Out What You NeedCisco Gigabit Ethernet Switch Module Description UID1 LEDPort Description HP c-Class BladeSystem Architecture Rear View of the Blade ServerInstalling the Switch Module in the Blade Server This equipment. StatementLever for the interconnect module blank Switch module release latch Running Express Setup Switch Module IP AddressesInformation You Need to Run Express Setup Page CBS 153144 Page Page Page Completing the Express Setup Fields Page Using the Device Manager Managing the Switch ModuleRefreshing the PC IP Address Command-Line Interface Case of Difficulty Onboard Administrator Command-Line InterfaceOther Management Options Troubleshooting Express Setup Resetting the Switch Module Accessing Help OnlineFor More Information Cisco.com Obtaining DocumentationProduct Documentation DVD Ordering Documentation Documentation Feedback Cisco Product Security OverviewReporting Security Problems in Cisco Products Obtaining Technical Assistance Submitting a Service RequestCisco Technical Support & Documentation Website Definitions of Service Request Severity Obtaining Additional Publications and InformationPage Hardware Warranty Terms Cisco 90-Day Limited Hardware Warranty TermsHP Hardware Warranty Terms Replacement, Repair, or Refund Policy for HardwareDocument Page Page USA
Top Page Image Contents