Cisco Systems 3020 warranty Introduction, Taking Out What You Need

Page 2

1Introduction

This guide provides instructions on how to install your Cisco Catalyst Blade Switch 3020 for HP—hereafter referred to as the switch module—in the HP c-Class BladeSystem and to set up and configure your switch module. The HP c-ClassBladeSystem—hereafterreferred to as the blade server—supports up to eight Ethernet switch modules, which are installed in the interconnect bays of the blade server.

This guide also covers management options and troubleshooting help for the switch module.

For details on the numbers, types, and the location of the blade server bays, for additional information on the blade server system, and for detailed port mapping information, see the HP BladeSystem enclosure installation poster or the HP BladeSystem enclosure setup and installation guide at http://www.hp.com/go/bladesystem/documentation.

For additional installation and configuration information about the switch module, see the Cisco Catalyst Blade Switch 3020 for HP documentation on Cisco.com. For system requirements, important notes, limitations, open and resolved caveats, and last-minute documentation updates about the switch module, see the release notes, also on Cisco.com.

When using the online publications, refer to the documents that match the Cisco IOS software version that is running on the switch module. See the “Obtaining Documentation” section on page 1-24 for more information about the switch module publications.

For translations of the warnings that appear in this publication and all safety and handling warnings for this product, see the Regulatory Compliance and Safety Information for the Cisco Catalyst Blade Switch 3020 for HP that accompanies this guide.

Before proceeding, read the release notes for the blade server. The release notes are available on the HP support website at www.support.hp.com.

2Taking Out What You Need

These items ship with your switch module:

•Console cable

•Cisco Catalyst Blade Switch 3020 for HP Getting Started Guide (this book)

•Regulatory Compliance and Safety Information for the Cisco Catalyst Blade Switch 3020 for HP

•Registration card

Follow these steps:

1.Unpack and remove the switch module and the accessory kit from the shipping box.

2.Return the packing material to the shipping container, and save it for future use.

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Including License and Warranty Introduction Taking Out What You NeedCisco Gigabit Ethernet Switch Module Description UID1 LEDPort Description HP c-Class BladeSystem Architecture Rear View of the Blade ServerInstalling the Switch Module in the Blade Server This equipment. StatementLever for the interconnect module blank Switch module release latch Running Express Setup Switch Module IP AddressesInformation You Need to Run Express Setup Page CBS 153144 Page Page Page Completing the Express Setup Fields Page Refreshing the PC IP Address Managing the Switch ModuleUsing the Device Manager Command-Line Interface Other Management Options Onboard Administrator Command-Line InterfaceCase of Difficulty Troubleshooting Express Setup Resetting the Switch Module Accessing Help OnlineFor More Information Product Documentation DVD Ordering Documentation Obtaining DocumentationCisco.com Documentation Feedback Cisco Product Security OverviewReporting Security Problems in Cisco Products Cisco Technical Support & Documentation Website Submitting a Service RequestObtaining Technical Assistance Definitions of Service Request Severity Obtaining Additional Publications and InformationPage Hardware Warranty Terms Cisco 90-Day Limited Hardware Warranty TermsHP Hardware Warranty Terms Replacement, Repair, or Refund Policy for HardwareDocument Page Page USA
Top Page Image Contents