Cisco Systems VIP-FE-TX/4E 4E Port Adapter LEDs, 4E Port Adapter Receptacles, Cables, and Pinouts

VIP Port Adapter Functions

4E Port Adapter LEDs

The 4E port adapter contains the enabled LED, standard on all port adapters, and a one status LED for each port. After system initialization, the enabled LED goes on to indicate that the 4E port adapter has been enabled for operation. (The LEDs are shown in Figure 25.) The following conditions must be met before the enabled LED goes on:

•

•

•

The 4E interface is correctly connected to the backplane and receiving power.

The 4E-equipped VIP contains a valid microcode version that has been downloaded successfully.

The bus recognizes the 4E-equipped VIP.

If any of these conditions is not met, or if the initialization fails for other reasons, the enabled LED does not go on.

When an RJ-45 port is active, its link LED is on when the 4E port adapter is receiving a carrier signal from the network.

Figure 25 LEDs on the 4E Port Adapter (Horizontal Orientation Shown)

ENABLED

3	LINK
1		3
0		2

H4492

4E Port Adapter Receptacles, Cables, and Pinouts

The interface connectors on the 4E port adapter are four individual RJ-45 receptacles. You can use all four simultaneously. Each connection supports IEEE 802.3 and Ethernet 10BASE-T interfaces compliant with appropriate standards. The RJ-45 connections require external transceivers.

Figure 26 shows the RJ-45 connectors. Table 12 lists the pinouts and signals for the RJ-45 connectors.

Figure 26 4E RJ-45 Connections, Plug and Receptacle

87654321

J-45 connector

H2936

Warning The ports labeled “Ethernet,” “10BaseT,” “Token Ring,” “Console,” and “AUX” are

safety extra-low voltage (SELV) circuits. SELV circuits should only be connected to other SELV circuits. Because the BRI circuits are treated like telephone-network voltage, avoid connecting the SELV circuit to the telephone network voltage (TNV) circuits. (For translated versions of this warning, refer to the section “SELV Circuit Warning Translations” on page 57.)

VIP-FE-TX/4E Installation and Configuration 47