Cisco Systems VIP-FE-TX/4E manual Router# sh int e 3/1/0

VIP Port Adapter Functions

Following is an example of how the show interfaces [type slot/port adapter/port] command displays status information (including the physical slot and port address) for the interfaces you specify. In these examples, most of the status information for each interface is omitted, and the four Ethernet 10BASE-T interfaces (0–3) are in chassis slot 3, in port adapter slot 1. (Interfaces are administratively shut down until you enable them.)

Router# sh int e 3/1/0

Ethernet3/1/1 is administratively down, line protocol is down

Hardware is cyBus Ethernet, address is 0000.0ca5.2300 (bia 0000.0ca5.2389) MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 1/255 Encapsulation ARPA, loopback not set, keepalive set (10 sec)

Router# sh int e 3/1/1

Ethernet3/1/2 is administratively down, line protocol is down

Hardware is cyBus Ethernet, address is 0000.0ca5.2300 (bia 0000.0ca5.238a) MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 1/255 Encapsulation ARPA, loopback not set, keepalive set (10 sec)

Router# sh int e 3/1/2

Ethernet3/1/3 is administratively down, line protocol is down

Hardware is cyBus Ethernet, address is 0000.0ca5.2300 (bia 0000.0ca5.238b) MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 1/255 Encapsulation ARPA, loopback not set, keepalive set (10 sec)

Router# sh int e 3/1/3

Ethernet3/1/3 is administratively down, line protocol is down

Hardware is cyBus Ethernet, address is 0000.0ca5.2300 (bia 0000.0ca5.238b) MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 1/255 Encapsulation ARPA, loopback not set, keepalive set (10 sec)

Ethernet 10BASE-T interface port adapters are always numbered as port adapter 1 because VIPs currently support only one 4E port adapter with the FE-TX/4E configuration, and the 4E port adapter is always in the second port adapter slot location (port adapter slot 1). With this VIP configuration, a FE-TX port adapter is always in port adapter slot 0.

Note Refer to the section “Selecting Chassis Slot, Port Adapter, and Fast Ethernet Interface Port Numbers,” on page 38, for your FE-TX interface.

VIP-FE-TX/4E Installation and Configuration 53