Cisco Systems ACIP-SM(=) manual Product Numbers ACIP-SM=

Page 1

Customer Order Number:

DOC-784256=

Documentation Part Number:

78-4256-01

ATM Cable Interface Processor (ACIP)

Installation and Configuration

Product Numbers: ACIP-SM(=)

This publication contains instructions for installing and performing a basic configuration of the Asynchronous Transfer Mode (ATM) Cable Interface Processor (ACIP). This publication contains basic configuration steps and examples.

Sections in this publication include the following:

ATM Terms and Acronyms, page 2

Asynchronous Transfer Mode Overview, page 3

ACIP Description, page 4

ACIP Installation Prerequisites, page 9

Installing and Removing an ACIP, page 16

Attaching Network Interface Cables to the ACIP, page 17

Using LEDs to Check ACIP Status, page 17

Using show Commands to Verify Interface Status, page 19

Configuring the ACIP, page 21

Checking the Configuration, page 26

Using the Debug ATM Commands, page 27

Examples of ATM Error Messages, page 28

Cisco Connection Online, page 32

Corporate Headquarters

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, CA 95134-1706

USA

Copyright © 1997

 

Cisco Systems, Inc.

1

All rights reserved.

Image 1
Contents Product Numbers ACIP-SM= ATM Terms and Acronyms Asynchronous Transfer Mode Overview Acip Description Acip FeaturesAcip Interface Power BudgetSonet Distance Limitations Approximating the Acip Power Margin Acip Cables, PLIM, and Connections Multimode Power Budget Example of Dispersion LimitDuplex SC-Type Connector Acip Software Prerequisites Acip Installation PrerequisitesHardware and Host Router Prerequisites Cisco 7507, Interface Processor End Cisco 7513, Interface Processor End Safety Warnings Safety GuidelinesList of Parts and Tools Acip Installation Prerequisites Preventing Electrostatic Discharge Damage Telephone WiringElectrical Equipment Acip Installation Prerequisites Install a module as follows Installing and Removing an AcipRemove a module as follows Attaching Network Interface Cables to the Acip Using LEDs to Check Acip StatusUsing LEDs to Check Acip Status Router# show version Using show Commands to Verify Interface StatusRouter# show cont cbus Configuring the Acip Configure an Acip Interface Acip Defaults Parameter Command Default ValueConfigure Cable Parameters Configure the Integrated Routing and Bridging FeatureConfigure the Bridge-Group Virtual Interface Interface bvi bridge-group Configure Protocols for Routing or BridgingConfiguration Example Monitor and Maintain the AcipATM show Commands Acip Error StatisticsChecking the Configuration Router# show atm vc Using the Debug ATM CommandsExamples of ATM Error Messages Examples of ATM Error Messages F4 Segment ATMATM2/0 VC1 Bad SAP received Cisco Connection Online