Cisco Systems ACIP-SM(=) manual Configuring the Acip

Page 21

Configuring the ACIP

Configuring the ACIP

Configuring the ACIP is a two step process: first you configure the ACIP, then you configure the cable headend and/or ATM switch. To configure ATM, complete the following tasks. The first two tasks are required, and then you must configure at least one PVC or SVC. The VC options you configure must match in three places: on the router, on the ATM switch, and at the remote end of the PVC or SVC connection.

Enable the ACIP.

Configure cable parameters.

Monitor and maintain the ATM interface (optional).

Note To configure your TeraLink 1000 cable headend and/or ATM switch, refer to the appropriate product’s user documentation.

Perform the tasks in the following sections to configure the ACIP interface (all tasks are required except for the last task):

Configure an ACIP Interface, page 22

Configure Cable Parameters, page 23

Configure the Integrated Routing and Bridging Feature, page 23

Configure the Bridge-Group Virtual Interface, page 23

Configure Protocols for Routing or Bridging, page 24

Monitor and Maintain the ACIP, page 25

Note After you configure the ACIP, you must configure the cable headend and/or ATM switch.

For information on additional commands that can be used with the ACIP, refer to the Cisco IOS Release 11.2(7)P feature guide. For an example ACIP configuration, refer to the section “Configuration Example” on page 25.

ATM Cable Interface Processor (ACIP) Installation and Configuration 21

Image 21
Contents Product Numbers ACIP-SM= ATM Terms and Acronyms Asynchronous Transfer Mode Overview Acip Description Acip FeaturesPower Budget Acip InterfaceSonet Distance Limitations Approximating the Acip Power Margin Acip Cables, PLIM, and Connections Multimode Power Budget Example of Dispersion LimitDuplex SC-Type Connector Acip Installation Prerequisites Acip Software PrerequisitesHardware and Host Router Prerequisites Cisco 7507, Interface Processor End Cisco 7513, Interface Processor End Safety Guidelines Safety WarningsList of Parts and Tools Acip Installation Prerequisites Telephone Wiring Preventing Electrostatic Discharge DamageElectrical Equipment Acip Installation Prerequisites Installing and Removing an Acip Install a module as followsRemove a module as follows Attaching Network Interface Cables to the Acip Using LEDs to Check Acip StatusUsing LEDs to Check Acip Status Router# show version Using show Commands to Verify Interface StatusRouter# show cont cbus Configuring the Acip Configure an Acip Interface Acip Defaults Parameter Command Default ValueConfigure the Integrated Routing and Bridging Feature Configure Cable ParametersConfigure the Bridge-Group Virtual Interface Interface bvi bridge-group Configure Protocols for Routing or BridgingConfiguration Example Monitor and Maintain the AcipAcip Error Statistics ATM show CommandsChecking the Configuration Router# show atm vc Using the Debug ATM CommandsExamples of ATM Error Messages Examples of ATM Error Messages F4 Segment ATMATM2/0 VC1 Bad SAP received Cisco Connection Online