Cisco Systems ACIP-SM(=) manual ATMATM2/0 VC1 Bad SAP received

Page 31

Examples of ATM Error Messages

Error Message

atm_pakalign(ATM2/0): Invalid VC(65535) received, type=0xaaaa

Explanation A packet was received by the ACIP with a VC that is out of the valid range of VCs.

Error Message

atm_pakalign(ATM2/0): VC(1) NOT conﬁgured, type=0xaaaa

Explanation A packet was received by the ACIP for which a VC is not conﬁgured.

Error Message

ATM(ATM2/0): Encapsulation error, link=0xaaaa, host=0xaaaa

Explanation The ATM software failed to encapsulate a protocol because the protocol/address are not in a STATIC map table.

Error Message

ATM(ATM2/0: Encapsulation error, VC=1 not connected

Explanation A static map exists for the protocol address, but the VC has not been conﬁgured.

Error Message

ATM(ATM2/0): VC(1) Bad SAP received

Explanation A packet with a bad SNAP encapsulation was received.

Error Message

ATM(ATM2/0): Bad VC(1) encapsulation configured

Explanation An internal error has occurred. Check the VC encapsulation.

ATM Cable Interface Processor (ACIP) Installation and Configuration 31

Image 31

Contents Product Numbers ACIP-SM= ATM Terms and Acronyms Asynchronous Transfer Mode Overview Acip Description Acip FeaturesAcip Interface Power BudgetSonet Distance Limitations Approximating the Acip Power Margin Acip Cables, PLIM, and Connections Multimode Power Budget Example of Dispersion LimitDuplex SC-Type Connector Acip Software Prerequisites Acip Installation PrerequisitesHardware and Host Router Prerequisites Cisco 7507, Interface Processor End Cisco 7513, Interface Processor End Safety Warnings Safety GuidelinesList of Parts and Tools Acip Installation Prerequisites Preventing Electrostatic Discharge Damage Telephone WiringElectrical Equipment Acip Installation Prerequisites Install a module as follows Installing and Removing an AcipRemove a module as follows Attaching Network Interface Cables to the Acip Using LEDs to Check Acip StatusUsing LEDs to Check Acip Status Router# show version Using show Commands to Verify Interface StatusRouter# show cont cbus Conﬁguring the Acip Conﬁgure an Acip Interface Acip Defaults Parameter Command Default ValueConﬁgure Cable Parameters Conﬁgure the Integrated Routing and Bridging FeatureConﬁgure the Bridge-Group Virtual Interface Interface bvi bridge-group Conﬁgure Protocols for Routing or BridgingConﬁguration Example Monitor and Maintain the AcipATM show Commands Acip Error StatisticsChecking the Conﬁguration Router# show atm vc Using the Debug ATM CommandsExamples of ATM Error Messages Examples of ATM Error Messages F4 Segment ATMATM2/0 VC1 Bad SAP received Cisco Connection Online