Cisco Systems ACIP-SM(=) manual Acip Installation Prerequisites

Page 15

ACIP Installation Prerequisites

•When removing an ACIP, use the ejectors to release the bus connectors from the backplane. Hold the handle on the front of an ACIP with one hand and support the bottom edge of the metal carrier with the other hand. Pull the carrier out slowly, using your hand along the bottom of the carrier to guide an ACIP straight out of the slot.

•Handle carriers by the handles and carrier edges only; avoid touching the board or any connector pins.

•Place a removed ACIP board-side-up on an antistatic surface or in a static shielding bag. If the component will be returned to the factory, immediately place an ACIP in a static shielding bag.

•Avoid contact between an ACIP and clothing. The wrist strap only protects the board from ESD voltages on the body; ESD voltages on clothing can still cause damage.

Caution For safety, periodically check the resistance value of the antistatic strap. The measurement should be between 1 and 10 megohms.

ATM Cable Interface Processor (ACIP) Installation and Configuration 15

Image 15

Contents Product Numbers ACIP-SM= ATM Terms and Acronyms Asynchronous Transfer Mode Overview Acip Description Acip FeaturesPower Budget Acip InterfaceSonet Distance Limitations Approximating the Acip Power Margin Acip Cables, PLIM, and Connections Multimode Power Budget Example of Dispersion LimitDuplex SC-Type Connector Acip Installation Prerequisites Acip Software PrerequisitesHardware and Host Router Prerequisites Cisco 7507, Interface Processor End Cisco 7513, Interface Processor End Safety Guidelines Safety WarningsList of Parts and Tools Acip Installation Prerequisites Telephone Wiring Preventing Electrostatic Discharge DamageElectrical Equipment Acip Installation Prerequisites Installing and Removing an Acip Install a module as followsRemove a module as follows Attaching Network Interface Cables to the Acip Using LEDs to Check Acip StatusUsing LEDs to Check Acip Status Router# show version Using show Commands to Verify Interface StatusRouter# show cont cbus Conﬁguring the Acip Conﬁgure an Acip Interface Acip Defaults Parameter Command Default ValueConﬁgure the Integrated Routing and Bridging Feature Conﬁgure Cable ParametersConﬁgure the Bridge-Group Virtual Interface Interface bvi bridge-group Conﬁgure Protocols for Routing or BridgingConﬁguration Example Monitor and Maintain the AcipAcip Error Statistics ATM show CommandsChecking the Conﬁguration Router# show atm vc Using the Debug ATM CommandsExamples of ATM Error Messages Examples of ATM Error Messages F4 Segment ATMATM2/0 VC1 Bad SAP received Cisco Connection Online