ACIP Error Statistics
ACIP Error Statistics
The ACIP maintains a count of certain errors. In addition to keeping a count of these errors, the ACIP also takes a snapshot of the last VCI/VPI that caused the error. Each ACIP error counter is 16 bits.
Errors include the following:
•
•
•
•
•
•
CRC errors
Giants received
No buffers available
Framing errors
Applique/physical layer errors
Packet timeout errors on receive
Checking the Configuration
After configuring the new interface, use the show commands to display the status of the new interface or all interfaces.
ATM show Commands
In addition to the show commands described in the section “Using show Commands to Verify Interface Status,” on page 19, you can use the following additional show commands to display the current state of the ATM network and the connected VCs:
•To show current VCs and traffic information, use the show atm vc [vcd] command: Specifying a VCD will display specific information about that VCD.
•To show current
•To show current ATM traffic, use the show atm traffic command:
This command displays global traffic information to and from all ATM networks connected to the router.
Following are descriptions and examples of the preceding show commands:
•Use the show atm vc command to display the following types of statistics for all VCs:
Router# show atm vc |
|
|
|
|
|
|
|
| |
|
|
|
|
| AAL / | Peak | Avg. | Burst |
|
Interface | VCD | VPI | VCI Type | Encapsulation | Kbps | Kbps | Cells Status | ||
ATM3/0.1 | 1 | 16 | 32 | PVC | 8192 | 8192 | 1024 | ACTIVE | |
ATM3/0.1 | 2 | 16 | 33 | PVC | 8192 | 8192 | 1024 | ACTIVE | |
26ATM Cable Interface Processor (ACIP) Installation and Configuration