Cisco Systems DPC3827, EPC3827 Wireless Basic Settings Page Description, Wireless Configuration

Configure Wireless Settings

Wireless Basic Settings Page Description

Use the following table to configure the basic settings for wireless communication for the residential gateway. After you make your selections, click Save Settings to apply your changes or Cancel Changes to cancel.

Section	Field Description
Basic Settings	Wireless Network
	Enable or Disable the wireless network.
	Wireless Configuration
	The default is WPS. Select Wi-Fi Protected Setup to set up your
	network using this option. The Wi-Fi Protected Setup feature
	automatically configures an encryption-secured, wireless network.
	To use Wi-Fi Protected Setup, you must have at least one other
	device that supports Wi-Fi Protected Setup in your network. After
	you have configured your Wi-Fi Protected Setup devices, you can
	manually configure other devices	.

See Wi-Fi Protected Setup (WPS) for more information about using WPS.

Network Mode

Choose one of these options for the network mode:

G only, B/G Mixed, B/G/N Mixed (factory default)

Important: When TKIP authentication only is selected, B/G/N

Mixed network mode is not available.

Radio Band

Select Enabled 2.4 GHz (factory default) or Enabled 5 GHz.

Note: The 5 GHz radio band may not be supported on some models.

Channel Width

Choose Standard - 20 MHz Channel or Wide 40 MHz Channel.

Standard Channel

Select one of the channels from the drop-down list to correspond with your network settings. All devices in your wireless network must broadcast on the same channel in order to communicate. You can select Auto (factory default) for automatic channel selection.

82 4025083 Rev A