Manage the Gateway
Select the Diagnostics tab to open the Administration Diagnostics page.
Use the descriptions and instructions in the following table to configure the diagnostics feature on the gateway. After you make your selections, click Save Settings to apply your changes or Cancel Changes to cancel.
Section | Field Description |
Ping Test | Ping Target IP |
Ping Test Parameters The IP address that you want to ping.
Ping Size
The size of the packet you want to use.
Number of Pings
The number of times you wish to ping the target device.
Ping Interval
The time period (milliseconds) between each ping.
Ping Timeout
The desired time period (milliseconds) of the timeout. If no response is received within this ping period, the ping test is considered a failure.
Start Test
To start a test, complete the following steps.
Click Start Test to begin the text. A new page opens and displays a summary of the test results.
Click the Save Settings to save the test results or click Cancel
Changes to cancel the test.
Administration > Backup & Restore
Administration Backup & Restore allows you to back up you configuration of the Gateway and store it on your computer. You can use this file to restore a previously saved configuration for your Gateway.
62 | 4025083 Rev A |