Cisco Systems 6500 manual Policy group, Banner value string, Filter tunnel ip-acl

Chapter 2 Commands for the Catalyst 6500 Series Switch WebVPN Module

policy group

policy group

	To define a group-policy template, associate a group-policy with a particular proxy server, and enter the
	group-policy submode, use the webvpn policy group command from context subcommand mode. Use
	the no form of this command to remove any commands that you have entered in the WebVPN
	subcommand mode from the configuration.
	policy group group-policy-name
	no policy group group-policy-name
Syntax Description	group-policy-nameName of the group policy.
Defaults	See the “Usage Guidelines” section for the submode command defaults.
Command Modes	WebVPN context submode
Command History	Release	Modification
	WebVPN Module	Support for this command was introduced on the Catalyst 6500 series
	Release 1.1	switches.
Usage Guidelines	The group-policy-nameargument is case-sensitive.
	After you enter the policy group command, the prompt changes to the following:
	webvpn(config-webvpn-group)#

Table 2-3lists the commands available to configure the group-policy template.

Table 2-3 Group-policy Commands

Command		Purpose and Guidelines	Defaults
banner value string		Specifies the banner string for the user or group. The string value	No string is specified.
		may contain 7-bit ASCII values, HTML tags, and escape
		sequences. This string is presented to the user after login.
exit		Exits from group-policy configuration mode.
filter tunnel {ip-acl		Defines the tunnel-specific access list.	No name is specified.
ip-expanded-acl		• ip-acl—IP access list (standard or extended); valid values are
name}
		from 1 to 199.
		• ip-expanded-acl—IP expanded access list (standard or
		extended); valid values are from 1300 to 2699.
		• name—Access-list name.
	Catalyst 6500 Series Switch WebVPN Module Command Reference—Release 1.1
2-38			OL-7310-01