Cisco Systems 6500 Svc, Command Modes WebVPN group context submode, Dns-server primary secondary

Chapter 2 Commands for the Catalyst 6500 Series Switch WebVPN Module

svc

svc

To configure the tunnel capabilities for a group-policy context, use the svc command. Use the no form of this command to remove any of the svc commands that you have entered.

	svc command
Syntax Description	command	Specifies the configuration command; see Table 2-5for a list of available
		commands.
Defaults	See Table 2-5for the default settings.

Command Modes WebVPN group context submode

Command History	Release	Modification
	WebVPN Module	Support for this command was introduced on the Catalyst 6500 series
	Release 1.1	switches.

Usage Guidelines The prompt for the svc command is the same as the group-policy prompt.

Table 2-5lists the commands available to configure tunnel-mode capability for a group context.

Table 2-5 Tunnel-Mode Configuration Commands

Command	Purpose and Guidelines	Default
address-pooladdress-pool-name	Assigns addresses from the pool to the remote users.
default-domaindefault-domain-name	Specifies the default domain to be used for the user/group,
	if tunnel-mode WebVPN is enabled for the user/group.
dns-server (primary secondary}	Specifies the primary and secondary DNS servers for web
ip-address	browsing. After the SSL VPN client (SVC) is installed, the
	active web browser is deactivated and a new browser is
	launched. The DNS server information specified here is for
	the newly launched browser. Once the connection is closed,
	the previous DNS settings are reapplied.

Catalyst 6500 Series Switch WebVPN Module Command Reference—Release 1.1

OL-7310-01 2-73