Cisco Systems 6500 manual Nbns-server ipaddr, Master timeout, Exit

Chapter 2 Commands for the Catalyst 6500 Series Switch WebVPN Module

nbns-list

Table 2-2 NBNSlist Submode Commands

Command		Purpose and Guidelines	Defaults
nbns-server ip_addr		Specifies a NetBIOS name service (NBNS) list and server address for	Timeout is 2 seconds.
[master] [timeout		common Internet file system (CIFS) name resolution. You can configure	Retries is 2 retries.
timeout][retry retries]		up to three servers.
		Note Supported only on Windows 2000 and Samba servers running on
		Linux.
		The ip_addrs value specifies the primary domain controller (PDC) on a
		Windows network.
		The master keyword indicates that this is a master browser. Do not enter
		the master keyword if this a Windows Internet Naming Service (WINS)
		server.
		The timeout value specifies the initial time in seconds to wait for a
		response to an NBNS query before sending the query to the next server.
		The default timeout value is 2 seconds; the range is from 1 to 30.
		The retries value specifies the number of times to retry sending a NBNS
		query to the configured servers. This value represents the number of times
		to cycle through the list of servers before returning an error. The default
		retries value is 2; the range is 0 to 10.
exit		Returns to context submode.
Examples	This example shows how to enter the nbnslist submode and configure the NBNS list and server address:
	webvpn(config)# webvpn context c1
	webvpn(config-webvpn-context)# nbns-list list2
	webvpn(config-webvpn-nbnslist)# nbns-server 10.1.1.2
	webvpn(config-webvpn-nbnslist)# exit
	webvpn(config-webvpn-context)#
	webvpn context
Related Commands

Catalyst 6500 Series Switch WebVPN Module Command Reference—Release 1.1

OL-7310-01 2-37