Supported Hardware
RSP720-3C-10GE
Product ID | Power | | Minimum |
(append “=” for spares) | Required | Product Description | Software Version |
| | | |
RSP720-3C-10GE | 7.33 A@42 V | Route Switch Processor 720 with uplink ports: | 12.2(33)SRC |
| | • Two 10 Gigabit Ethernet (10-GE) uplink ports support | |
| | |
| | 10-Gbps X2 modules | |
| | • Three Gigabit Ethernet (1-GE) uplink ports: two ports support | |
| | 1-Gbps small form-factor pluggable (SFP) module; one port | |
| | supports 10/100/1000-Mbps RJ-45 connector | |
| | • Integrated 720-Gbps switch fabric | |
| | • PFC3C and MSFC4 with 512-MB bootflash, 4-MB | |
| | NVRAM, 4-MB ROMmon, and several DRAM options: | |
| | – Route processor (RP): 1- to 2-GB DRAM (default 1 | |
| | GB) | |
| | – Switch processor (SP): 1- to 2-GB DRAM (default 1 | |
| | GB) | |
| | • One CompactFlash Type II slot (on front panel) and one | |
| | 2-GB internal CompactFlash (1 GB each for RP and SP) | |
| | • Requires larger power supplies and a high-speed fan tray | |
| | • QoS port architecture, 10-GE ports (Rx/Tx): 8q8t/1p7q8t | |
| | (CoS) | |
| | • QoS port architecture, 1-GE ports (Rx/Tx): 2q8t/1p3q8t | |
| | | |
Note | | | |
•There are no memory-only upgrade options for the RSP720-3C-10GE.
•The RSP720-3C-10GE does not support the following chassis and modules:
–Unsupported chassis: Cisco 7603, 7606, and 7613 chassis
–Unsupported modules: Services modules, Optical Service Modules (OSMs), FlexWAN module.
•The RSP720-3C-10GE supports the following 10-Gigabit Ethernet optics: X2-10GB-LR, X2-10GB-ER, X2-10GB-SR, X2-10GB-CX4, and X2-10GB-LX4.
•The RSP720-3C-10GE supports the following Gigabit Ethernet optics: GLC-SX-MM, GLC-LH-SM, GLC-ZX-SM, GLC-T, SFP-GE-S, SFP-GE-L, SFP-GE-T, and GLC-BX-D.
In Cisco IOS Release 12.2SRC, the RSP720-10GE does not support the following features, which are supported on the RSP720:
•High-availability features such as NonStop Forwarding with Stateful Switchover (NSF/SSO) and In-Service Software Upgrade (ISSU) are not supported. Only Route Processor Redundancy (RPR) mode is supported.
•The uplinks on the standby RSP720-10GE are not active. This restriction exists because the uplink ports must perform lookups on the active RSP, which is not possible in RPR mode.
•Broadband aggregation features are not supported.
Guide to Supported Hardware for Cisco 7600 Series Routers with Cisco IOS Release 12.2SR
