Cisco Systems 7304 manual Verify TTB Settings, Routerconfig-if# ttb country rnode serial, 13-16

Chapter 13 Configuring the 2-Port and 4-Port T3/E3 SPAs

Configuration Tasks

Command	Purpose
Router# configure terminal	Enters global configuration mode.
Router(config)# interface serial slot/subslot/port	Selects the interface to configure and enters
	interface configuration mode.
	• slot/subslot/port— Specifies the location of the
		interface. See the: “Specifying the Interface
		Address on a SPA” section on page 13-5
Router(config-if)#ttb {country rnode serial	Sends a Trace Trail Buffer message in E3 g.832
snode soperator x} string	framing mode.
	• country—Two character country code
	• rnode—Receive node code
	•	serial—M.1400 serial
	• snode—Sending location/Node ID code
	• soperator—Sending operator code. (must be
		numeric)
	•	x—X0
	•	string—TTB message.

Verify TTB Settings

Use the show controllers serial command to display the TTB settings for the interface:

router# show controllers serial 6/0/0 Serial6/0/0 -

Framing is c-bit, Clock Source is Line

Bandwidth limit is 44210, DSU mode 0, Cable length is 10 rx FEBE since last clear counter 2, since reset 0

Data in current interval (546 seconds elapsed):

0 Line Code Violations, 0 P-bit Coding Violation 0 C-bit Coding Violation

0 P-bit Err Secs, 0 P-bit Sev Err Secs

0 Sev Err Framing Secs, 0 Unavailable Secs

0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs Data in Interval 1:

0 Line Code Violations, 0 P-bit Coding Violation 0 C-bit Coding Violation

0 P-bit Err Secs, 0 P-bit Sev Err Secs

0 Sev Err Framing Secs, 0 Unavailable Secs

0 Line Errored Secs, 0 C-bit Errored Secs, 0 C-bit Sev Err Secs

.

.

.

No alarms detected.

TTB transmission is disabled

TTB Rx: country: us soperator: s snode: sn rnode: rn x: x serial: 1

	Cisco 7304 Router Modular Services Card and Shared Port Adapter Software Configuration Guide
13-16	OL-4807-02