Cisco Systems AIRCAP3602IAK9RF, AIRCAP3602ITK9 Screw down the thumb screws on the module

Page 17

Step 5 Screw down the thumb screws on the module.

Step 4 Align the module’s connector with the connector on the back of the access point and click the module into place.

345380

Step 5 Screw down the thumb screws on the module.

Note If the screws are not tightened, the module will not be recognized and may not operate correctly. Make sure not to over-tighten, only hand-tighten the screws.

Step 6 Power up the access point. When the access point boots up, it will recognize the module.

17

Image 17

Contents GETTING STARTED GUIDE Cisco Aironet 3600 Series Lightweight Access Points1 About this Guide 2 Introduction to the Access PointIMPORTANT SAFETY INSTRUCTIONS 3 Safety Instructionstranslated safety warnings that accompanied this device. Statement SAVE THESE INSTRUCTIONS20A. Statement External Antennas 5 Configurations4 Unpacking Countries Supported Internal AntennasRegulatory Domains 6 Access Point Ports and Connectors 272377 LED indicatorFigure 2 Access Point LED Indicator top-3602I Model The Controller Discovery Process 7 Configuring the Access PointPreparing the Access Point Performing a Pre-Installation Configuration Installation SummaryController Layer 3 devices Cisco Aironet access points Pre-Installation Configuration Setup2106 controller WS-C3550, WS-C3560, and WS-C3750 switches Step 2 Apply power to the access pointC1880 switch 2600, 2610, 2611, 2621, 2650, and 2651 multiservice platformsc. If the access point shuts down, check the power source 9 Deploying the Access Point on the Wireless Network 8 Mounting the Access PointInstalling a Module 10 Installing ModulesStep 5 Screw down the thumb screws on the module Guidelines for Using Cisco Aironet Lightweight Access Points 11 TroubleshootingUsing DHCP Option Checking the Access Point LEDStatus LED LED Status Indications continued Troubleshooting the Access Point Join Process Tested To Comply With FCC Standards FOR HOME OR OFFICE USE 12 Declarations of Conformity and Regulatory InformationModule Models Access Point ModelsVCCI Statement for Japan Japanese Translation Guidelines for Operating Cisco Aironet Access Points in JapanEnglish Translation 03-6434-6500Canadian Compliance Statement Statement 371-Power Cable and AC AdapterIndustry Canada Module Models Access Point ModelsEuropean Community, Switzerland, Norway, Iceland, and Liechtenstein Page The following standards were applied Health & Safety-EN60950-1 2005 EN 50385EMC-EN 301.489-1 v1.8.1 EN 301.489-17 Radio-EN 300 328 v 1.7.1 EN 301.893 vGeneric Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Chinese Translation Administrative Rules for Cisco Aironet Access Points in TaiwanAdministrative Rules for Low-power Radio-Frequency Devices Article Regulatory Information Operation of Cisco Aironet Access Points in BrazilPortuguese Translation Declaration of Conformity StatementsCisco AP c3600 13 Configuring DHCP Option 43 and DHCP OptionCisco AP c3600-ServiceProvider Type + Length + Value 14 Access Point SpecificationsSpecification CategoryAccess Point Specifications continued refer to Channels and Maximum Power Settings for Cisco Aironet15 Obtaining Documentation and Submitting a Service Request

Related manuals

Manual 52 pages 58.61 Kb