Cisco Systems AIRCAP3602ISK9 refer to Channels and Maximum Power Settings for Cisco Aironet

Page 39

Table 2	Access Point Specifications (continued)

Category		Specification

Compliance		The 3602 series access point complies with UL 2043 for products installed
		in a building’s environmental air handling spaces, such as above suspended
		ceilings.

Safety		UL 60950-1
		CAN/CSA C22.2 No. 60950-1
		IEC 60950-1 with all national deviations
		EN 60950-1
		UL 2043

EMI and Susceptibility		FCC Part 15.107 and 15.109 Class B
		ICES-003 Class B (Canada)
		EN 301.489
		EN 55022 Class B
		EN 55024
		VCCI Class B

Radio		FCC Part 15.247, 15.407
		Canada RSS-210
		Japan Telec 33, 66, T71
		EN 330.328, EN 301.893
		FCC Bulletin OET-65C
		Industry Canada RSS-102

Maximum power and		Maximum power and the channels allowed in your regulatory domain,
channel settings		refer to Channels and Maximum Power Settings for Cisco Aironet
		Lightweight Access Points. This document is available on Cisco.com.

39

Image 39

Contents

GETTING STARTED GUIDE Cisco Aironet 3600 Series Lightweight Access Points1 About this Guide 2 Introduction to the Access PointSAVE THESE INSTRUCTIONS 3 Safety InstructionsIMPORTANT SAFETY INSTRUCTIONS translated safety warnings that accompanied this device. Statement20A. Statement 5 Configurations 4 UnpackingExternal Antennas Internal Antennas Regulatory DomainsCountries Supported 6 Access Point Ports and Connectors LED indicator Figure 2 Access Point LED Indicator top-3602I Model272377 The Controller Discovery Process 7 Configuring the Access PointPreparing the Access Point Performing a Pre-Installation Configuration Installation SummaryController Layer 3 devices Cisco Aironet access points Pre-Installation Configuration Setup2600, 2610, 2611, 2621, 2650, and 2651 multiservice platforms Step 2 Apply power to the access point2106 controller WS-C3550, WS-C3560, and WS-C3750 switches C1880 switchc. If the access point shuts down, check the power source 9 Deploying the Access Point on the Wireless Network 8 Mounting the Access PointInstalling a Module 10 Installing ModulesStep 5 Screw down the thumb screws on the module Checking the Access Point LED 11 TroubleshootingGuidelines for Using Cisco Aironet Lightweight Access Points Using DHCP OptionStatus LED LED Status Indications continued Troubleshooting the Access Point Join Process Tested To Comply With FCC Standards FOR HOME OR OFFICE USE 12 Declarations of Conformity and Regulatory InformationModule Models Access Point ModelsVCCI Statement for Japan 03-6434-6500 Guidelines for Operating Cisco Aironet Access Points in JapanJapanese Translation English TranslationStatement 371-Power Cable and AC Adapter Industry CanadaCanadian Compliance Statement Access Point Models European Community, Switzerland, Norway, Iceland, and LiechtensteinModule Models Page Radio-EN 300 328 v 1.7.1 EN 301.893 v Health & Safety-EN60950-1 2005 EN 50385The following standards were applied EMC-EN 301.489-1 v1.8.1 EN 301.489-17Generic Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Chinese Translation Administrative Rules for Cisco Aironet Access Points in TaiwanAdministrative Rules for Low-power Radio-Frequency Devices Article Regulatory Information Operation of Cisco Aironet Access Points in BrazilPortuguese Translation Declaration of Conformity Statements13 Configuring DHCP Option 43 and DHCP Option Cisco AP c3600-ServiceProviderCisco AP c3600 Category 14 Access Point SpecificationsType + Length + Value SpecificationAccess Point Specifications continued refer to Channels and Maximum Power Settings for Cisco Aironet15 Obtaining Documentation and Submitting a Service Request

Related manuals

Manual 40 pages 31.6 Kb

Manual 52 pages 58.61 Kb