Cisco Systems AIRCAP3602EAK9 specifications Declarations of Conformity and Regulatory Information

Page 22

12Declarations of Conformity and Regulatory Information

•The access point is still connected to the same controller, and the global syslog server IP address configuration on the controller has been changed using the config ap syslog host global syslog_server_IP_address command. In this case, the controller sends the new global syslog server IP address to the access point.

•The access point is still connected to the same controller, and a specific syslog server IP address has been configured for the access point on the controller using the config ap syslog host specific Cisco_AP syslog_server_IP_address command. In this case, the controller sends the new specific syslog server IP address to the access point.

•The access point is disconnected from the controller and joins another controller. In this case, the new controller sends its global syslog server IP address to the access point.

•Whenever a new syslog server IP address overrides the existing syslog server IP address, the old address is erased from persistent storage, and the new address is stored in its place. The access point also starts sending all syslog messages to the new IP address provided the access point can reach the syslog server IP address.

You can configure the syslog server for access points and view the access point join information only from the controller CLI.

A detailed explanation of the join process is on Cisco.com at the following URL:

http://www.Cisco.com/en/US/products/ps6366/products_tech_note09186a00808f8599.shtml

12Declarations of Conformity and Regulatory Information

This section provides declarations of conformity and regulatory information for the Cisco Aironet 3602 series Access Point and any additional modules that can be installed into the Cisco Aironet 3602 series Access Point. You can find additional information at this URL:

www.cisco.com/go/aironet/compliance

Manufacturers Federal Communication Commission Declaration of Conformity Statement

Tested To Comply

With FCC Standards

FOR HOME OR OFFICE USE

22

Image 22

Contents Cisco Aironet 3600 Series Lightweight Access Points GETTING STARTED GUIDE2 Introduction to the Access Point 1 About this Guidetranslated safety warnings that accompanied this device. Statement 3 Safety InstructionsIMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS20A. Statement 4 Unpacking 5 ConfigurationsExternal Antennas Regulatory Domains Internal AntennasCountries Supported 6 Access Point Ports and Connectors Figure 2 Access Point LED Indicator top-3602I Model LED indicator272377 7 Configuring the Access Point The Controller Discovery ProcessPreparing the Access Point Installation Summary Performing a Pre-Installation ConfigurationPre-Installation Configuration Setup Controller Layer 3 devices Cisco Aironet access pointsC1880 switch Step 2 Apply power to the access point2106 controller WS-C3550, WS-C3560, and WS-C3750 switches 2600, 2610, 2611, 2621, 2650, and 2651 multiservice platformsc. If the access point shuts down, check the power source 8 Mounting the Access Point 9 Deploying the Access Point on the Wireless Network10 Installing Modules Installing a ModuleStep 5 Screw down the thumb screws on the module Using DHCP Option 11 TroubleshootingGuidelines for Using Cisco Aironet Lightweight Access Points Checking the Access Point LEDStatus LED LED Status Indications continued Troubleshooting the Access Point Join Process 12 Declarations of Conformity and Regulatory Information Tested To Comply With FCC Standards FOR HOME OR OFFICE USEAccess Point Models Module ModelsVCCI Statement for Japan English Translation Guidelines for Operating Cisco Aironet Access Points in JapanJapanese Translation 03-6434-6500Industry Canada Statement 371-Power Cable and AC AdapterCanadian Compliance Statement European Community, Switzerland, Norway, Iceland, and Liechtenstein Access Point ModelsModule Models Page EMC-EN 301.489-1 v1.8.1 EN 301.489-17 Health & Safety-EN60950-1 2005 EN 50385The following standards were applied Radio-EN 300 328 v 1.7.1 EN 301.893 vDeclaration of Conformity for RF Exposure Generic Discussion on RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Administrative Rules for Cisco Aironet Access Points in Taiwan Chinese TranslationAdministrative Rules for Low-power Radio-Frequency Devices Article Operation of Cisco Aironet Access Points in Brazil Regulatory InformationDeclaration of Conformity Statements Portuguese TranslationCisco AP c3600-ServiceProvider 13 Configuring DHCP Option 43 and DHCP OptionCisco AP c3600 Specification 14 Access Point SpecificationsType + Length + Value Categoryrefer to Channels and Maximum Power Settings for Cisco Aironet Access Point Specifications continued15 Obtaining Documentation and Submitting a Service Request

Related manuals

Manual 52 pages 58.61 Kb