Cisco Systems AIRCAP3602EAK9, AIRCAP3602ITK9 English Translation, Chinese Translation

Page 34

Administrative Rules for Low-power Radio-Frequency Devices

English Translation

Administrative Rules for Low-power Radio-Frequency Devices

Article 12

For those low-power radio-frequency devices that have already received a type-approval, companies, business units or users should not change its frequencies, increase its power or change its original features and functions.

Article 14

The operation of the low-power radio-frequency devices is subject to the conditions that no harmful interference is caused to aviation safety and authorized radio station; and if interference is caused, the user must stop operating the device immediately and can't re-operate it until the harmful interference is clear.

The authorized radio station means a radio-communication service operating in accordance with the Communication Act.

The operation of the low-power radio-frequency devices is subject to the interference caused by the operation of an authorized radio station, by another intentional or unintentional radiator, by industrial, scientific and medical (ISM) equipment, or by an incidental radiator.

Chinese Translation

Image 34

Contents Cisco Aironet 3600 Series Lightweight Access Points GETTING STARTED GUIDE2 Introduction to the Access Point 1 About this Guidetranslated safety warnings that accompanied this device. Statement 3 Safety InstructionsIMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS20A. Statement 4 Unpacking 5 ConfigurationsExternal Antennas Regulatory Domains Internal AntennasCountries Supported 6 Access Point Ports and Connectors Figure 2 Access Point LED Indicator top-3602I Model LED indicator272377 7 Configuring the Access Point The Controller Discovery ProcessPreparing the Access Point Installation Summary Performing a Pre-Installation ConfigurationPre-Installation Configuration Setup Controller Layer 3 devices Cisco Aironet access pointsC1880 switch Step 2 Apply power to the access point2106 controller WS-C3550, WS-C3560, and WS-C3750 switches 2600, 2610, 2611, 2621, 2650, and 2651 multiservice platformsc. If the access point shuts down, check the power source 8 Mounting the Access Point 9 Deploying the Access Point on the Wireless Network10 Installing Modules Installing a ModuleStep 5 Screw down the thumb screws on the module Using DHCP Option 11 TroubleshootingGuidelines for Using Cisco Aironet Lightweight Access Points Checking the Access Point LEDStatus LED LED Status Indications continued Troubleshooting the Access Point Join Process 12 Declarations of Conformity and Regulatory Information Tested To Comply With FCC Standards FOR HOME OR OFFICE USEAccess Point Models Module ModelsVCCI Statement for Japan English Translation Guidelines for Operating Cisco Aironet Access Points in JapanJapanese Translation 03-6434-6500Industry Canada Statement 371-Power Cable and AC AdapterCanadian Compliance Statement European Community, Switzerland, Norway, Iceland, and Liechtenstein Access Point ModelsModule Models Page EMC-EN 301.489-1 v1.8.1 EN 301.489-17 Health & Safety-EN60950-1 2005 EN 50385The following standards were applied Radio-EN 300 328 v 1.7.1 EN 301.893 vDeclaration of Conformity for RF Exposure Generic Discussion on RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Administrative Rules for Cisco Aironet Access Points in Taiwan Chinese TranslationAdministrative Rules for Low-power Radio-Frequency Devices Article Operation of Cisco Aironet Access Points in Brazil Regulatory InformationDeclaration of Conformity Statements Portuguese TranslationCisco AP c3600-ServiceProvider 13 Configuring DHCP Option 43 and DHCP OptionCisco AP c3600 Specification 14 Access Point SpecificationsType + Length + Value Categoryrefer to Channels and Maximum Power Settings for Cisco Aironet Access Point Specifications continued15 Obtaining Documentation and Submitting a Service Request

Related manuals

Manual 52 pages 58.61 Kb