Cisco Systems AIRCAP3602ITK9, AIRCAP3602IAK9RF, AIRCAP3602EAK9, AIRCAP3602ISK9 20A. Statement

Page 4

20A. Statement 1005

Warning

Warning

Warning

Warning

Caution

Caution

Note

Note

4

Installation of the equipment must comply with local and national electrical codes. Statement 1074

This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the protective device is rated not greater than:

20A. Statement 1005

Do not operate your wireless network device near unshielded blasting caps or in an explosive environment unless the device has been modified to be especially qualified for such use. Statement 245B

In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a minimum of 7.9 inches (20 cm) or more from the body of all persons. Statement 332

The fasteners you use to mount an access point on a ceiling must be capable of maintaining a minimum pullout force of 20 lbs (9 kg) and must use all 4 indented holes on the mounting bracket.

This product and all interconnected equipment must be installed indoors within the same building, including the associated LAN connections as defined by Environment A of the IEEE 802.af Standard.

The access point is suitable for use in environmental air space in accordance with section 300.22.C of the National Electrical Code and sections 2-128, 12-010(3), and 12-100 of the Canadian Electrical Code, Part 1, C22.1. You should not install the power supply or power injector in air handling spaces.

Use only with listed ITE equipment.

Image 4

Contents Cisco Aironet 3600 Series Lightweight Access Points GETTING STARTED GUIDE2 Introduction to the Access Point 1 About this Guide3 Safety Instructions IMPORTANT SAFETY INSTRUCTIONStranslated safety warnings that accompanied this device. Statement SAVE THESE INSTRUCTIONS20A. Statement 4 Unpacking 5 ConfigurationsExternal Antennas Regulatory Domains Internal AntennasCountries Supported 6 Access Point Ports and Connectors Figure 2 Access Point LED Indicator top-3602I Model LED indicator272377 7 Configuring the Access Point The Controller Discovery ProcessPreparing the Access Point Installation Summary Performing a Pre-Installation ConfigurationPre-Installation Configuration Setup Controller Layer 3 devices Cisco Aironet access pointsStep 2 Apply power to the access point 2106 controller WS-C3550, WS-C3560, and WS-C3750 switchesC1880 switch 2600, 2610, 2611, 2621, 2650, and 2651 multiservice platformsc. If the access point shuts down, check the power source 8 Mounting the Access Point 9 Deploying the Access Point on the Wireless Network10 Installing Modules Installing a ModuleStep 5 Screw down the thumb screws on the module 11 Troubleshooting Guidelines for Using Cisco Aironet Lightweight Access PointsUsing DHCP Option Checking the Access Point LEDStatus LED LED Status Indications continued Troubleshooting the Access Point Join Process 12 Declarations of Conformity and Regulatory Information Tested To Comply With FCC Standards FOR HOME OR OFFICE USEAccess Point Models Module ModelsVCCI Statement for Japan Guidelines for Operating Cisco Aironet Access Points in Japan Japanese TranslationEnglish Translation 03-6434-6500Industry Canada Statement 371-Power Cable and AC AdapterCanadian Compliance Statement European Community, Switzerland, Norway, Iceland, and Liechtenstein Access Point ModelsModule Models Page Health & Safety-EN60950-1 2005 EN 50385 The following standards were appliedEMC-EN 301.489-1 v1.8.1 EN 301.489-17 Radio-EN 300 328 v 1.7.1 EN 301.893 vDeclaration of Conformity for RF Exposure Generic Discussion on RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Administrative Rules for Cisco Aironet Access Points in Taiwan Chinese TranslationAdministrative Rules for Low-power Radio-Frequency Devices Article Operation of Cisco Aironet Access Points in Brazil Regulatory InformationDeclaration of Conformity Statements Portuguese TranslationCisco AP c3600-ServiceProvider 13 Configuring DHCP Option 43 and DHCP OptionCisco AP c3600 14 Access Point Specifications Type + Length + ValueSpecification Categoryrefer to Channels and Maximum Power Settings for Cisco Aironet Access Point Specifications continued15 Obtaining Documentation and Submitting a Service Request

Related manuals

Manual 52 pages 58.61 Kb