Site Preparation and Safety Information
Figure 5 | Class 1 Laser Label for a Chassis |
CLASS 1 LASER PRODUCT
LASERPRODUKT DER KLASSE 1
PRODUIT LASER DE CLASSE 1
PRODUCTO LASER CLASE 1
Fiber optic lasers, when they are installed,
comply with DHHS Rules 21 CFR Subchapter J,
applicable at date of manufacture.
Manufactured:
APPARATEN SKALL ANSLUTAS |
|
TILL JORDET NÄTUTTAG. | B1 |
11536
Preventing EMI
When you run wires for any significant distance in an electromagnetic field, electromagnetic interference (EMI) can occur between the field and the signals on the wires.
Note that:
•Bad plant wiring can result in radio frequency interference (RFI).
•Strong EMI, especially when it is caused by lightning or radio transmitters, can destroy the signal drivers and receivers in the system, and can even create an electrical hazard by conducting power surges through lines and into the system.
To predict and remedy strong EMI, consult RFI experts.
Covering Empty Slots
Ensure that all cards, faceplates, and covers are in place. Blank faceplates and cover panels are used to:
•Prevent exposure to hazardous voltages and currents inside the chassis
•Help contain electromagnetic interference (EMI) that might disrupt other equipment
•Direct the flow of cooling air through the chassis
Disposing of the System
Dispose of the system and its components (including batteries) as specified by all national laws and regulations.
Regulatory Compliance and Safety Information for the Cisco 7301 Internet Router
| 67 |
| |
|
|