Baracoda LA manual Sniff period settings

Page 16

Data Capture for Workforce in Motion

1.7.2.Sniff period settings

Change the Sniff period. If the higher is the latency and the smaller is the power consumption. Default value is 150ms.

Sniff period = 150ms (*)

Sniff period = 100ms

Sniff period = 200ms

Sniff period = 300ms

Sniff period = 500ms

RoadRunners Evolution –L (1D) & -LA (Laser) – Programming Guide v1.3

- 16 -

Image 16

Contents RoadRunners Evolution -L 1D & -LA Laser Programming Guide Summary Appendix 1 Ascii Table A-Z, A-Z, 0-9, PUNCTUATION, Control Revision History Introduction General Configuration General default settingsBaracoda advanced features Switch on delayShutdown timers Turn scanner OFFReading Mode No data loss mode and Baracoda HeaderAutoscan Operating Mode Real Time modeReal Time mode No Data Loss mode Enable ACK beepNo Data Loss mode Disable ACK beep Real Time Buffered data optionBatch mode Batch ModeDifferent connection methods Buzzer and Led Settings LED OFFBluetooth settings Bluetooth nameSniff period settings Security code PIN settings RF Power emission settingsData format Timestamp optionYES Data Prefix/Suffix Barcode Prefix/Suffix AIM Symbology Identifier Enable/Disable All Symbologies Decoder default settingsSet decoder barcode length Voting Min/Max length per symbology Symbology table Codabar settingsEnable/Disable Codabar Codabar Check Digit Verification AIM recommendation Codabar Start/Stop charactersSet Lengths for Codabar Code 11 Settings Enable/Disable CodeCode 11 check digits verification Transmit Code 11 check digitsEnable/Disable Code 39 Full Ascii Code 39 settingsCode 39 Start/stop characters Code 39 Check Digit Verification Accepted Code 39 charactersSet lengths for Code Code 93 Settings Italian PharmaCode settingsEnable/Disable Code 128/EAN Code 128 SettingsSet lengths for Code 128/EAN EAN 128 Group Separator Interleaved 2 of 5 Settings Enable/Disable AIM ID TransmissionEnable/Disable Interleaved 2 Interleaved 2of 5 Check DigitMSI Code Settings Enable/Disable MSISet lengths for Interleaved 2 MSI Check DigitStandard 2 of 5 Settings Enable/Disable Standard 2Set lengths for MSI Standard 2 of 5 Check DigitEnable/Disable UPC/EAN UPC/ EAN SettingsSet lengths for Standard 2 Transmit EAN13 Check Digit Transmit UPC-E Check DigitTransmit EAN 8 Check Digit Transmit UPC-A Check DigitTransmit UPC number system for UPC-E UPC-A, UPC-E, EAN conversionsISSN/ISBN settings Add-on digits settings15. GS1 DataBar RSS 14 Settings Enable/Disable GS1 DataBar15.2. GS1 DataBar 14 Check Digit Transmission 15.3. GS1 DataBar 14 Linkage flag Transmission16. GS1 DataBar RSS Limited Settings Enable/Disable GS1 DataBar Limited16.2. GS1 DataBar Limited Check Digit Transmission 16.3. GS1 DataBar Limited Linkage flag TransmissionCapital letters A-Z Small letters a-z Ponctuation Decimal numbers Control Characters Appendix 2 AIM symbology identifiers structure