Baracoda LA manual Data Prefix/Suffix

Page 20

Data Capture for Workforce in Motion

1.8.2.Data Prefix/Suffix

You can add a data prefix and/or suffix (strings of more than 32 characters will not be accepted) to every barcode sent to the host device.

There is no data prefix or suffix in default settings.

Enable data prefix

Disable data prefix (*)

Enable data suffix

Disable data suffix (*)

If enabled, a data prefix/suffix can be set as following:

Start

Read « « set prefix (suffix) » barcode

Read intermediary label corresponding to the next character to set for the prefix (suffix)

(see appendix 1)

NO

Finished ?

YES

Read « end of config » barcode

End

Procedure to define Data/Barcode Prefix/Suffix

RoadRunners Evolution –L (1D) & -LA (Laser) – Programming Guide v1.3

- 20 -

Image 20
Contents RoadRunners Evolution -L 1D & -LA Laser Programming Guide Summary Appendix 1 Ascii Table A-Z, A-Z, 0-9, PUNCTUATION, Control Revision History Introduction General Configuration General default settingsBaracoda advanced features Switch on delayShutdown timers Turn scanner OFFReading Mode No data loss mode and Baracoda HeaderAutoscan Operating Mode Real Time modeReal Time mode No Data Loss mode Enable ACK beepNo Data Loss mode Disable ACK beep Real Time Buffered data optionBatch mode Batch ModeDifferent connection methods Buzzer and Led Settings LED OFFBluetooth settings Bluetooth nameSniff period settings Security code PIN settings RF Power emission settingsData format Timestamp optionYES Data Prefix/Suffix Barcode Prefix/Suffix AIM Symbology Identifier Set decoder barcode length Decoder default settingsEnable/Disable All Symbologies Voting Min/Max length per symbology Enable/Disable Codabar Codabar settingsSymbology table Set Lengths for Codabar Codabar Start/Stop charactersCodabar Check Digit Verification AIM recommendation Code 11 Settings Enable/Disable CodeCode 11 check digits verification Transmit Code 11 check digitsCode 39 Start/stop characters Code 39 settingsEnable/Disable Code 39 Full Ascii Set lengths for Code Accepted Code 39 charactersCode 39 Check Digit Verification Code 93 Settings Italian PharmaCode settingsSet lengths for Code 128/EAN Code 128 SettingsEnable/Disable Code 128/EAN EAN 128 Group Separator Interleaved 2 of 5 Settings Enable/Disable AIM ID TransmissionEnable/Disable Interleaved 2 Interleaved 2of 5 Check DigitMSI Code Settings Enable/Disable MSISet lengths for Interleaved 2 MSI Check DigitStandard 2 of 5 Settings Enable/Disable Standard 2Set lengths for MSI Standard 2 of 5 Check DigitSet lengths for Standard 2 UPC/ EAN SettingsEnable/Disable UPC/EAN Transmit EAN13 Check Digit Transmit UPC-E Check DigitTransmit EAN 8 Check Digit Transmit UPC-A Check DigitTransmit UPC number system for UPC-E UPC-A, UPC-E, EAN conversionsISSN/ISBN settings Add-on digits settings15. GS1 DataBar RSS 14 Settings Enable/Disable GS1 DataBar15.2. GS1 DataBar 14 Check Digit Transmission 15.3. GS1 DataBar 14 Linkage flag Transmission16. GS1 DataBar RSS Limited Settings Enable/Disable GS1 DataBar Limited16.2. GS1 DataBar Limited Check Digit Transmission 16.3. GS1 DataBar Limited Linkage flag TransmissionCapital letters A-Z Small letters a-z Ponctuation Decimal numbers Control Characters Appendix 2 AIM symbology identifiers structure