RoadRunners
2.3.2/ Shutdown timers
There are two differents ‘shutdown timers’ :
-when connected timer : delay between the last scanned barcode and the switch off when the scanner is connected to a host
-Not connected timer : delay between the last scanned barcode and the switch off when the scanner is not connected to any host
It is possible to set those timers to ‘infinite’. In that case, the scanner will stay all the time ON.
Set shutdown timers to infinity
By default, timers value are :
when connected timer = 20 minutes Not connected timer = 10 minutes
Set shutdown timers to defaults
2.3.3/ No data loss mode and Baracoda Header
Baracoda header:
It is a proprietary data encapsulation. It is necessary to activate it to use the Baracoda keyboard emulation (Kemul) and Hyper terminal.
The Baracoda header is enabled in default settings
No data loss mode:
Baracoda has developed a proprietary communication protocol in order to enhance the security of the Bluetooth transmission.
Every barcode sent to the host must be acknowledged by the host (until then, the scanner will transmit it again and again).
This acknowledgment is disabled in default settings. It is strongly recommended to set this protocol acknowledgment on when using the scanner with the BaracodaManager.
Enable Baracoda header + “No Data loss mode” ON
Disable Baracoda header + “No data loss mode” OFF
Enable Baracoda header
+ “No Data loss mode” OFF (*)
© Baracoda 2007 | 5/29 |