Cabletron Systems 9H531-24, 9H532-24, 9H533-24 manual Installing the Module

Page 25

Installing the SmartSwitch 9000 Module

3.Grasp the module and slide it into the slots. Make sure that the moduleÕs circuit card is between the card guides, as shown in Figure 2-2.Check both the upper and lower tracks of the card. Take care that the module slides in straight and engages the backplane connectors properly.

4.Lock down the top and bottom plastic tabs, as shown in Figure 2-2.

Jack for ESD wrist strap

Metal Back-Panel

Circuit Card

Card Guides

Warning:

Ensure that the circuit card is between the card guides.

Lock down the top and bottom plastic tabs at the same time, applying even pressure.

Figure 2-2. Installing the Module

2-5

Image 25

Contents 9033050-02 Page FCC Notice Cabletron SYSTEMS, INC Program License Agreement Iii Cabletron Systems Limited Program License Agreement Page Page Declaration of Conformity Viii Contents Contents Introduction FeaturesIntroduction Auto-Negotiation Management Broadcast Suppression Priority Indicator Transmit Queue Switching Options Related Manuals Introduction Unpacking the Module User Accessible ComponentsInstalling the SmartSwitch 9000 Module Switch Function Description Using DIP Switch Installing the Module into the SmartSwitch 9000 ChassisInstalling the Module Reset Switch Reset Switch10BASE-T Network Cabling Requirements100BASE-TX Network 100BASE-FX NetworkInstalling the SmartSwitch 9000 Module Technical Overview SmartSwitch ArchitectureTechnical Overview System Management BusesSMB-1 Bus System Diagnostic ControllerSMB-10 Bus INB Interface DC/DC ConverterI960 Core Lanview LEDs LED Mode SwitchLanview LEDs Functions of the INB transmit LED are listed in Table Functions of the INB receive LED are listed in Table DPX Status LEDs 9H532-24 only Lanview LEDs Technical Speciﬁcations SpeciﬁcationsRegulatory Compliance ServicePhysical