Cabletron Systems STHI manual Installing the Sthi

Installing the STHI

Figure 3-4. Installing the Wall-Mounting Brackets

2.Select a wall location for the STHI within 7 feet of a power outlet.

Potential SHOCK HAZARD: Select a wall location where WARNING pilot holes for screws will not intersect with electrical wiring

in the wall.

3.Get a pencil and refer to Figure 3-5. With the wall-mounting brackets attached to the STHI, position the STHI against the wall where it will be permanently mounted, with the network ports facing down, and mark the screw holes’ positions on the wall.

4.Set the STHI aside and carefully drill four 1/4” pilot holes for the screw anchors, one at each mark made in step 3.

5.Install the screw anchors. If installing on a hollow wall, use the provided Molly bolt anchors (pictured in collapsed form as “Hollow Wall Anchor” in Figure 3-5): insert the anchor into the hole, tighten the screw to collapse the anchor’s bracing arms, and remove the screw. If installing on a solid wall, a different type of anchor will be required.

6.Position the STHI on the wall, aligning the screw holes over the anchors, and fasten the STHI to the anchors with the four anchor screws. Tighten the screws.

Page 3-4