Cabletron Systems STHI manual Reset Button, Management Failure

The Reset Button

Management Failure 4

If the MGMT LED is red, try resetting the STHI. If this does not resolve the problem, contact Cabletron Systems Tech Support. Meanwhile, the STHI will continue to operate, but will not provide Beacon Recovery or statistical monitoring.

4.3 The Reset Button

The STHI incorporates a recessed Reset button (see Figure 4-1). Pressing this button causes the STHI to clear all counters, run all startup diagnostics, and reload the flash resident firmware into the CPU local memory. It does NOT initialize Non-Volatile Random Access Memory (NVRAM), the battery-backed random access memory where the STHI stores network management parameters. (See also Section 4.4, NVRAM Reset Switch.)

HubSTACK TOKEN RING HUB WITH LANVIEW®

SUPPORTING 100 OHM UTP CABLE

STHI-24

4M

16M

SPEED

CPU	ACT
16 Mb/s	MGMT
COM	RO

Reset Button

Figure 4-1. Reset Button

NOTE

Management services will be suspended during the reset process.

Page 4-3