Cabletron Systems manual Connecting the EMC39-12 to the Power Source

Page 15

Chapter 2: Installation

2.3CONNECTING THE EMC39-12 TO THE POWER SOURCE

NOTE

The EMC39-12 has a universal power supply. This allows you to connect the EMC39-12 to power sources from 100 Vac to 125 Vac, 50-60 Hz or 200 Vac to 240 Vac, 50-60 Hz

To connect the EMC39-12 to the power source:

1.Plug the power cord into the back panel of the EMC39-12.

2.Plug the other end of the power cord into a grounded wall outlet.

3.Verify that the PWR LED is on; this indicates that the EMC39-12 is receiving power.

Page 2-4

EMC39-12 User’s Guide

Image 15

Contents EMC39-12Ethernet Media Converter with Lanview Port Ethernet Media Converter USER’S GuidePage EMC39-12 User’s Guide FCC Notice Cabletron SYSTEMS, INC. Program License Agreement United States Government Restricted Rights Table of Contents Chapter Introduction Using this ManualEMC39-12 Overview Getting HelpAutomatic Transmit Port Disable EMC39-12 FeaturesEnvironmental Requirements EMC39-12 SpecificationsChapter Installation Installing the EMC39-12Unpacking the EMC39-12 Rack Mounting the EMC39-12 Free-Standing Shelf or Tabletop Installation Connecting the EMC39-12 to the Power Source Connecting a Twisted Pair Segment to the EMC39-12 Chapter Connecting to the NetworkConnecting To The Network Connecting a Fiber Optic Link Segment Connecting a Fiber Link to the EMC39-12 Finishing the Installation EMC39-12 Chapter Using the Lanview LedsRCV Receive Single Mode Fiber Optic Network Appendix a Cable Requirements10BASE-T Twisted Pair Requirements A-2 EMC39-12 User’s Guide Twisted Pair Wiring from AN EMC39-12 to a Punch Down Block Appendix B Twisted Pair Wiring TablesB-2 EMC39-12 User’s Guide Twisted Pair Wiring From An EMC39-12 To a Punch Down Block B-4 EMC39-12 User’s Guide Twisted Pair Wiring from a Punch Down bLOCK to a B-6 EMC39-12 User’s Guide EMC39-12 User’s Guide B-7 B-8 EMC39-12 User’s Guide Power Supply Cord