Cabletron Systems EMC39-12 manual FCC Notice

Page 4

Notice

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

DOC NOTICE

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

VCCI NOTICE

This equipment is in the 1st Class Category (information equipment to be used in commercial and/or industrial areas) and conforms to the standards set by the Voluntary Control Council for Interference by Information Technology Equipment (VCCI) aimed at preventing radio interference in commercial and/or industrial areas.

Consequently, when used in a residential area or in an adjacent area thereto, radio interference may be caused to radios and TV receivers, etc.

Read the instructions for correct handling.

iv

EMC39-12 User’s Guide

Image 4
Contents Port Ethernet Media Converter USER’S Guide EMC39-12Ethernet Media Converter with LanviewPage EMC39-12 User’s Guide FCC Notice Cabletron SYSTEMS, INC. Program License Agreement United States Government Restricted Rights Table of Contents Using this Manual Chapter IntroductionGetting Help EMC39-12 OverviewEMC39-12 Features Automatic Transmit Port DisableEMC39-12 Specifications Environmental RequirementsInstalling the EMC39-12 Chapter InstallationUnpacking the EMC39-12 Rack Mounting the EMC39-12 Free-Standing Shelf or Tabletop Installation Connecting the EMC39-12 to the Power Source Chapter Connecting to the Network Connecting a Twisted Pair Segment to the EMC39-12Connecting To The Network Connecting a Fiber Optic Link Segment Connecting a Fiber Link to the EMC39-12 Finishing the Installation Chapter Using the Lanview Leds EMC39-12RCV Receive Appendix a Cable Requirements Single Mode Fiber Optic Network10BASE-T Twisted Pair Requirements A-2 EMC39-12 User’s Guide Appendix B Twisted Pair Wiring Tables Twisted Pair Wiring from AN EMC39-12 to a Punch Down BlockB-2 EMC39-12 User’s Guide Twisted Pair Wiring From An EMC39-12 To a Punch Down Block B-4 EMC39-12 User’s Guide Twisted Pair Wiring from a Punch Down bLOCK to a B-6 EMC39-12 User’s Guide EMC39-12 User’s Guide B-7 B-8 EMC39-12 User’s Guide Power Supply Cord