Cabletron Systems manual EMC39-12 User’s Guide

Page 3

NOTICE

Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.

The hardware, firmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

Copyright 1996 by Cabletron Systems, Inc., P.O. Box 5005, Rochester, NH 03866-5005 All Rights Reserved

Printed in the United States of America

Order Number: 9031854 January 1996

SPECTRUM, LANVIEW, MicroMMAC, and BRIM are registered trademarks and Element Manager, EPIM, EPIM-A,EPIM-F1,EPIM-F2,EPIM-F3,EPIM-T,EPIM-X,FOT-F,FOT-F3,

HubSTACK, SEH, SEHI, and TMS-3are trademarks of Cabletron Systems, Inc.

All other product names mentioned in this manual may be trademarks or registered trademarks of their respective companies.

Printed on

Recycled Paper

EMC39-12 User’s Guide

iii

Image 3
Contents EMC39-12Ethernet Media Converter with Lanview Port Ethernet Media Converter USER’S GuidePage EMC39-12 User’s Guide FCC Notice Cabletron SYSTEMS, INC. Program License Agreement United States Government Restricted Rights Table of Contents Chapter Introduction Using this ManualEMC39-12 Overview Getting HelpAutomatic Transmit Port Disable EMC39-12 FeaturesEnvironmental Requirements EMC39-12 SpecificationsChapter Installation Installing the EMC39-12Unpacking the EMC39-12 Rack Mounting the EMC39-12 Free-Standing Shelf or Tabletop Installation Connecting the EMC39-12 to the Power Source Connecting a Twisted Pair Segment to the EMC39-12 Chapter Connecting to the NetworkConnecting To The Network Connecting a Fiber Optic Link Segment Connecting a Fiber Link to the EMC39-12 Finishing the Installation EMC39-12 Chapter Using the Lanview LedsRCV Receive Single Mode Fiber Optic Network Appendix a Cable Requirements10BASE-T Twisted Pair Requirements A-2 EMC39-12 User’s Guide Twisted Pair Wiring from AN EMC39-12 to a Punch Down Block Appendix B Twisted Pair Wiring TablesB-2 EMC39-12 User’s Guide Twisted Pair Wiring From An EMC39-12 To a Punch Down Block B-4 EMC39-12 User’s Guide Twisted Pair Wiring from a Punch Down bLOCK to a B-6 EMC39-12 User’s Guide EMC39-12 User’s Guide B-7 B-8 EMC39-12 User’s Guide Power Supply Cord