Chapter 3: Connecting To The Network
To connect the EMC39-12 to a 10BASE-T compliant Ethernet device:
1.Attach a 50-pin feeder cable to the Champ connector on the EMC39-12 as shown in Figure 3-1.
EMC39-12Ethernet Media Converter WITH LANVIEW
12X1X
Figure 3-1 EMC39-12
2.Attach the other end of the 50-pin feeder cable to the Champ connector on the 10BASE-T compliant Ethernet device.
3.Check that the link LED on the 10BASE-T ethernet device and the applicable TPLNK LED on the EMC39-12 are on. If the LEDs are not on, perform each of the following steps until the LEDs are on:
a.Check that the 10BASE-T device and the EMC39-12 have power.
b.Verify the cabling between the EMC39-12 and the 10BASE-T device.
c.Check the cable for continuity.
If a link has not been established, contact Cabletron Systems Technical Support.
Page 3-2 | EMC39-12 User’s Guide |
