Cabletron Systems manual Rack Mounting the EMC39-12

Chapter 2: Installation

2.2.1 Rack Mounting the EMC39-12

Before installing the EMC39-12, care must be taken to ensure that the rack used will support the unit and that the rack remains stable with the EMC39-12 installed. In order to allow for proper cooling within the rack, there must be a two-inch clearance on either side of the unit. Refer to Chapter 1, Introduction for power and environmental requirements.

The following procedures explain how to install the EMC39-12 in a 19-inch rack.

1.Remove four cover screws (two from each side) located along the front edges of each side of the EMC39-12. Figure 2-1 shows the location of the screws.

Do not remove the cover from the EMC39-12. There are no user configurable devices inside and the electronics are static sensitive.

2.Using the four cover screws removed in step 1, attach the rack mounting brackets to each end of the EMC39-12.

Rack Mounting

Brackets (2)

EMC39-12Ethernet Media Converter WITH LANVIEW

	TPLINK
	XMT		RX	TX	RX TX	RX TX	RX TX	RX TX	RX TX	RX TX	RX TX	RX TX	RX TX	RX TX	RX TX
	RCV
PWR	FOLNK	12 11 10 9 8 7 6 5 4 3 2 1
			12		11	10	9	8	7	6	5	4	3	2	1

Screws (4)

Figure 2-1 Installing the Rackmount Brackets

Page 2-2 EMC39-12 User’s Guide