Powering Up and Stacking the SEH
5.Attach the interconnect cable to the “IN” port on the rear panel of the SEH as shown in Figure
REAR VIEW
SEHI Managing 4 SEH Non-Intelligent Hubs
OUT
SEH100TX INTERCONNECT
IN
OUT
SEH100TX INTERCONNECT
IN
OUT
SEH100TX INTERCONNECT
IN
OUT
SEH100TX INTERCONNECT
IN
OUT
SEHI100TX INTERCONNECT
IN
1511_07
Figure 4-5 Stacking the SEH and SEHI
6.Attach the other end of the interconnect cable to the “OUT” port on the rear panel of the hub at the bottom of the stack.
Do not leave an interconnect cable connected at only one end
!during network operation. Corrupted data may result.
CAUTION
7. Repeat steps 3 through 6 until all SEH hubs are connected.
SEH100TX User’s Guide |