Cabletron Systems SEH100TX-22 manual Position X crossed over RX+ TX+ Position = Not crossed over

Connecting the SEH100TX-22 to the Network

The EPIM-100TX is also used to provide another RJ45 port to connect to a UTP segment. Before connecting a segment to the EPIM-100TX, check each end of the segment to determine if the wires have been crossed over for the proper connection. If the wires do not cross over, use the switch on the EPIM-100TX to internally cross over the RJ45 port. Refer to Figure 5-2 to set the EPIM-100TX crossover switch.

Position X (crossed over)

1. RX+	5. NC
2. RX-	6. TX-
3. TX+	7. NC
4. NC	8. NC

Position =

(not crossed over)

1. TX+	5.	NC
2. TX-	6.	RX-
3. RX+	7. NC
4. NC	8. NC		1511_11

Figure 5-2 EPIM-100TX Crossover Switch

Connect an EPIM-100TX to a twisted pair segment as follows:

1.Connect the twisted pair segment to the module by plugging the RJ45 connector on the twisted pair segment into the RJ45 port on the module. See Figure 5-2.

2.Plug the RJ45 connector at the other end of the twisted pair segment into the other device as appropriate.

3.Check that the LNK LED on the EPIM-100TX is on. If the LED is off, perform each of the following steps until it is on:

a.Check that the 100BASE-TX device at the other end of the twisted pair segment is powered up.

b.Verify that the RJ45 connector on the twisted pair segment has the proper pinouts.

SEH100TX User’s Guide 5-3