Cabletron Systems SEH100TX-22 manual Cabletron Software Program License

Page 5

Notice

CABLETRON SOFTWARE PROGRAM LICENSE

1.LICENSE. You have the right to use only the one (1) copy of the Program provided in this package subject to the terms and conditions of this License Agreement.

You may not copy, reproduce or transmit any part of the Program except as permitted by the Copyright Act of the United States or as authorized in writing by Cabletron.

2.OTHER RESTRICTIONS. You may not reverse engineer, decompile, or disassemble the Program.

3.APPLICABLE LAW. This License Agreement shall be interpreted and governed under the laws and in the state and federal courts of New Hampshire. You accept the personal jurisdiction and venue of the New Hampshire courts.

EXCLUSION OF WARRANTY AND DISCLAIMER OF LIABILITY

1.EXCLUSION OF WARRANTY. Except as may be specifically provided by Cabletron in writing, Cabletron makes no warranty, expressed or implied, concerning the Program (including its documentation and media).

CABLETRON DISCLAIMS ALL WARRANTIES, OTHER THAN THOSE SUPPLIED TO YOU BY CABLETRON IN WRITING, EITHER EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH RESPECT TO THE PROGRAM, THE ACCOMPANYING WRITTEN MATERIALS, AND ANY ACCOMPANYING HARDWARE.

2.NO LIABILITY FOR CONSEQUENTIAL DAMAGES. IN NO EVENT SHALL CABLETRON OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS, PROFITS, BUSINESS INTERRUPTION, LOSS OF BUSINESS INFORMATION, SPECIAL, INCIDENTAL, CONSEQUENTIAL, OR RELIANCE DAMAGES, OR OTHER LOSS) ARISING OUT OF THE USE OR INABILITY TO USE THIS CABLETRON PRODUCT, EVEN IF CABLETRON HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. BECAUSE SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, OR ON THE DURATION OR LIMITATION OF IMPLIED WARRANTIES, IN SOME INSTANCES THE ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO YOU.

UNITED STATES GOVERNMENT RESTRICTED RIGHTS

The enclosed product (a) was developed solely at private expense; (b) contains “restricted computer software” submitted with restricted rights in accordance with Section 52227-19 (a) through (d) of the Commercial Computer Software - Restricted Rights Clause and its successors, and (c) in all respects is proprietary data belonging to Cabletron and/or its suppliers.

For Department of Defense units, the product is licensed with “Restricted Rights” as defined in the DoD Supplement to the Federal Acquisition Regulations, Section 52.227-7013 (c) (1) (ii) and its successors, and use, duplication, disclosure by the Government is subject to restrictions as set forth in subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at

252.227-7013. Cabletron Systems, Inc., 35 Industrial Way, Rochester, New Hampshire 03867-0505.

SEH100TX User’s Guide

iii

Image 5
Contents 100BASE-T Stackable HUB USER’S Guide Page SEH100TX User’s Guide DOC Notice Cabletron Software Program License Declaration of Conformity Contents Contents Chapter Introduction Using this ManualFollowing conventions are used throughout this document Document ConventionsYour email address Getting HelpRelated Manuals HubSTACK 100BASE-TX HUB with Lanview SEH100TX-22 Chapter SEH Features and OptionsSEH Overview SEH FeaturesRack Mounting Capabilities Stackable CapabilitiesEpim Optional EPIMsHubSTACK Interconnect Cable Requirements Chapter Installation Requirements SpecificationsCable Specifications UTP Cable Specifications Multimode Fiber Optic Cable Specifications Class I Network Network Cable LengthsRJ45 Network Port Pinouts Network Port SpecificationsAgency Approvals Operating SpecificationsImmunity Physical SpecificationsSEH100TX User’s Guide Unpacking the SEH Chapter InstallationHubSTACK 100BASE-TX HUB with Lanview SEH100TX-22 Tabletop or Shelf InstallationScrews Strain-Relief Bracket Rackmount InstallationRack Mounting the SEH Powering Up and Stacking the SEH Powering UP and Stacking the SEHStacking SEH Hubs with an Sehi Repeat steps 3 through 6 until all SEH hubs are connected Stacking Unmanaged SEH Hubs Together Installing AN EpimInstalling an Epim SEH100TX User’s Guide Connecting to Network Ports Chapter Connecting to the NetworkConnecting the SEH100TX-22 to the Network SEH Network Ports Connecting to an EPIM-100TXPosition X crossed over RX+ TX+ Position = Not crossed over Nnecting an EPIM-100FX or EPIM-100FMB EPIM-100FX Port Testing the InstallationSEH100TX User’s Guide Installation Test Chapter TroubleshootingUsing Lanview SEH100TX-22 Epim 1 RCV LED Epim 2 RCV LED EPIM-100TX Epim SpecificationsAppendix a Epim Information EPIM-100FX Figure A-3 EPIM-100FMB EPIM-100FMBTable A-2 provides the specifications for the EPIM-100FMB Numerics IndexIndex-2 SEH100TX User’s Guide Power Supply Cord