Cabletron Systems 2H253-25R manual Specifications, Device Specifications, Physical Properties

Page 49

A

Specifications

This appendix provides operating specifications for the Cabletron Systems 2H253-25R. Cabletron Systems reserves the right to change these specifications at any time without notice.

A.1 DEVICE SPECIFICATIONS

 

Processors:

Intel i960 RISC processor Power PC

Dynamic Random Access

 

Memory (DRAM):

20 MB expandable to 32 MB

FLASH Memory:

8 MB

Shared Memory:

4 MB

A.2 PHYSICAL PROPERTIES

Dimensions:

7.11H x 43.18W x 46.99D (cm)

 

2.8H x 17W x 18.5D (in)

Approximate Weight (Unit):

8.18 kg (18 lb)

MTBF (Predicted):

200,000 hours

Specifications A-1

Image 49
Contents 2H253-25R SmartSwitch Installation User’s Guide Page Page FCC Notice Cabletron SYSTEMS, INC Program License Agreement Page Page Page Cabletron Systems Limited Program License Agreement Viii Declaration of Conformity Page Contents Troubleshooting Figures Tables About This Guide Using this GuideStructure of this Guide Xvi Related DocumentsDocument Conventions Document ConventionsPage Overview IntroductionAuto-Negotiation ConnectivityRuntime IP Address Discovery Full Duplex Switched EthernetSmartTrunk Broadcast Suppression Remote Monitoring RmonPort/VLAN Redirect Functions Flow Control Rate LimitingSwitching Options Garp Switch Operation12 802.1 Port Priority ManagementOptional HSIMs and VHSIMs Lanview Diagnostic LEDsStandards Compatibility Year 2000 CompliantGetting Help 10BASE-T Network Network Requirements100BASE-TX Network Unpacking the Device InstallationInstalling the Device Installing OptionsGuidelines for Tabletop and Shelf Installations Tabletop or Shelf InstallationGuidelines for the Rackmount Installation Rackmount InstallationAttaching the Strain-Relief Bracket Rack Mounting the 2H253-25R Redundant Primary AC outlets are On separate circuits Connecting PowerConnecting to the Network Straight Cable Connection Completing the Installation Using Lanview TroubleshootingPWR CPU FDX OFF Troubleshooting ChecklistSeries 2E253, 2H252, 2H253, User parameters Position of Mode switch IP address Reset Button Using the Reset ButtonSpecifications Device SpecificationsPhysical Properties Environmental Requirements Electrical SpecificationsINPUT/OUTPUT Ports Regulatory Compliance COM Port Pinout AssignmentsPage Required Tools Optional Installations Mode Switch Bank SettingsRemoving the Chassis Cover Removing the Chassis Cover Figure B-1 Removing the Chassis Cover Switch 6 Forced BootP Setting the Mode SwitchesSimm Upgrade Locating SIMMs Installing the Dram SimmFigure B-4 Installing the Dram Figure B-5 Hsim and Vhsim Connector Locations Installing Optional Hsim or Vhsim Interface ModulesPage Numerics IndexIndex-2