Cabletron Systems 2H253-25R manual FCC Notice

Page 4

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause interference in which case the user will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

INDUSTRY CANADA NOTICE

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.

VCCI NOTICE

This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.

ii

Image 4
Contents 2H253-25R SmartSwitch Installation User’s Guide Page Page FCC Notice Cabletron SYSTEMS, INC Program License Agreement Page Page Page Cabletron Systems Limited Program License Agreement Viii Declaration of Conformity Page Contents Troubleshooting Figures Tables About This Guide Using this GuideStructure of this Guide Related Documents XviDocument Conventions Document ConventionsPage Introduction OverviewConnectivity Auto-NegotiationRuntime IP Address Discovery Full Duplex Switched EthernetSmartTrunk Broadcast Suppression Remote Monitoring RmonPort/VLAN Redirect Functions Rate Limiting Flow ControlGarp Switch Operation Switching Options12 802.1 Port Priority ManagementLanview Diagnostic LEDs Optional HSIMs and VHSIMsStandards Compatibility Year 2000 CompliantGetting Help Network Requirements 10BASE-T Network100BASE-TX Network Installation Unpacking the DeviceInstalling Options Installing the DeviceTabletop or Shelf Installation Guidelines for Tabletop and Shelf InstallationsRackmount Installation Guidelines for the Rackmount InstallationAttaching the Strain-Relief Bracket Rack Mounting the 2H253-25R Connecting Power Redundant Primary AC outlets are On separate circuitsConnecting to the Network Straight Cable Connection Completing the Installation Troubleshooting Using LanviewPWR CPU FDX Troubleshooting Checklist OFFSeries 2E253, 2H252, 2H253, User parameters Position of Mode switch IP address Using the Reset Button Reset ButtonSpecifications Device SpecificationsPhysical Properties Environmental Requirements Electrical SpecificationsINPUT/OUTPUT Ports COM Port Pinout Assignments Regulatory CompliancePage Optional Installations Mode Switch Bank Settings Required ToolsRemoving the Chassis Cover Removing the Chassis Cover Figure B-1 Removing the Chassis Cover Setting the Mode Switches Switch 6 Forced BootPSimm Upgrade Installing the Dram Simm Locating SIMMsFigure B-4 Installing the Dram Installing Optional Hsim or Vhsim Interface Modules Figure B-5 Hsim and Vhsim Connector LocationsPage Index NumericsIndex-2