Cabletron Systems 2H253-25R manual Installing Optional Hsim or Vhsim Interface Modules

Page 61

Installing Optional HSIM or VHSIM Interface Modules

B.5 INSTALLING OPTIONAL HSIM OR VHSIM INTERFACE MODULES

Figure B-5 shows the location of the two connectors for an optional High HSIM or VHSIM. Depending on the HSIM or VHSIM installed, one or both connectors are used.

NOTE

The installation instructions for the optional HSIM or VHSIM are in the associated user’s guide.

TOP VIEW WITHOUT COVER

Primary

Power

Supply

Redundant

Power

Supply

Optional

HSIM or VHSIM

Connectors

FRONT PANEL

2504-31

Figure B-5 HSIM and VHSIM Connector Locations

Optional Installations and Mode Switch Bank Settings

B-9

Image 61
Contents 2H253-25R SmartSwitch Installation User’s Guide Page Page FCC Notice Cabletron SYSTEMS, INC Program License Agreement Page Page Page Cabletron Systems Limited Program License Agreement Viii Declaration of Conformity Page Contents Troubleshooting Figures Tables About This Guide Using this GuideStructure of this Guide Xvi Related DocumentsDocument Conventions Document ConventionsPage Overview IntroductionAuto-Negotiation ConnectivityRuntime IP Address Discovery Full Duplex Switched EthernetSmartTrunk Broadcast Suppression Remote Monitoring RmonPort/VLAN Redirect Functions Flow Control Rate LimitingSwitching Options Garp Switch Operation12 802.1 Port Priority ManagementOptional HSIMs and VHSIMs Lanview Diagnostic LEDsStandards Compatibility Year 2000 CompliantGetting Help 10BASE-T Network Network Requirements100BASE-TX Network Unpacking the Device InstallationInstalling the Device Installing OptionsGuidelines for Tabletop and Shelf Installations Tabletop or Shelf InstallationGuidelines for the Rackmount Installation Rackmount InstallationAttaching the Strain-Relief Bracket Rack Mounting the 2H253-25R Redundant Primary AC outlets are On separate circuits Connecting PowerConnecting to the Network Straight Cable Connection Completing the Installation Using Lanview TroubleshootingPWR CPU FDX OFF Troubleshooting ChecklistSeries 2E253, 2H252, 2H253, User parameters Position of Mode switch IP address Reset Button Using the Reset ButtonSpecifications Device SpecificationsPhysical Properties Environmental Requirements Electrical SpecificationsINPUT/OUTPUT Ports Regulatory Compliance COM Port Pinout AssignmentsPage Required Tools Optional Installations Mode Switch Bank SettingsRemoving the Chassis Cover Removing the Chassis Cover Figure B-1 Removing the Chassis Cover Switch 6 Forced BootP Setting the Mode SwitchesSimm Upgrade Locating SIMMs Installing the Dram SimmFigure B-4 Installing the Dram Figure B-5 Hsim and Vhsim Connector Locations Installing Optional Hsim or Vhsim Interface ModulesPage Numerics IndexIndex-2