Extron electronic MC104 IP Create a Display Disconnection E-mail IP model only, Build menu

Software Setup, cont’d

Display lamp hour e-mail notification

9. Click Done. The dialog box closes.

Step 9: Create a Display Disconnection E-mail (IP model only)

To set a display disconnected e-mail alert, do the following:

1.	Click the Monitor tab in the Global Configurator window.
2.	Click the Add Monitor button below the Monitored
	Conditions window. The Monitored Conditions Wizard
	window appears.
3.	Enter a name (enter Disconnected) in the Enter Monitored
	Condition Name field area. The label now appears in the
	left pane.
4.	Click Next to specify a condition.
5.	Select the desired equipment (for our purposes, choose the
	Epson PowerLite 7700p) from the Subject Port window
	and Connection Status: Disconnected from Available
	Options.
6.	Click Apply Condition, then click Next.

7.	Click Next again to add an e-mail notification.
8.	Highlight the appropriate e-mail message (Disconnect
	Notification) and contacts (e-mail recipient), and click
	Apply Email/Contacts.
9.	Click Done. The dialog box closes.

Step 10: Build and Upload a Configuration

The Global Configurator project file contains all the configuration data (port assignments, product/device locations, scheduling data, etc.) you have created in Global Configurator. This is the data used to build the project's GlobalViewer Web pages for the MLC 104 IP.

Building a configuration

To build a configuration, do the following:

1.	Click the GlobalViewer tab at the left pane window to open
	GlobalViewer Designer.
2.	Confirm that all configured products have been given a
	location. If not, drag each product to the desired location
	or create new ones.

3.Save your project file. If a project file has not been saved, GC prompts you to do so before building the configuration.

4. From the Build menu, choose Build All Configurations or Build Changed Configurations.

The Build menu

An activity bar appears, indicating that the build is progressing. The Upload Manager dialog appears when the build is complete.

3-20 MLC 104 Series MediaLink Controllers • Software Setup MLC 104 Series MediaLink Controllers • Software Setup 3-21