Extron electronic MC104 IP setup guide MLC 104 MediaLink Controllers, Table of Contents, cont’d

Page 5

Table of Contents, cont’d

Step 9: Create a Display Disconnection E-mail

 

(IP model only)

3-20

Step 10: Build and Upload a Configuration

3-21

Building a configuration

3-21

Uploading a configuration

3-22

Accessing GlobalViewer®

3-23

68-1315-01 Rev. A

08 06

All trademarks mentioned in this manual are the properties of their respective owners.

MLC 104 MediaLink Controllers

Chapter1One

Introduction

About this Manual

About the MLC 104 MediaLink Controllers

About Global Configurator

System Requirements

Installing the Software

Updating Firmware

iiMLC 104 Series MediaLink • Table of Contents

Page 4 Page 6
Image 5
Page 4 Page 6
Contents
MLC 104 and MLC 104 IP Series Precautions 安全须知 中文 Table of Contents MLC 104 MediaLink Controllers Table of Contents, cont’dIntroduction About Global ConfiguratorAbout this Manual About the MLC 104 Medialink ControllersIntroduction, cont’d Installing the SoftwareSystem Requirements Updating FirmwareTwo An MLC 104 series controller daisy chained to a SCP Hardware SetupRight Side Panel Features and Connections Power wiring Hardware Setup, cont’dButtons Left SideConfiguration host control port Volume controlPin out for TRS RS-232 cable wiring Baud Stop bit No parity Data bits No flow controlIP model only Software SetupDownload Device Drivers Project Settings dialog box Software Setup, cont’d Create a New ProjectAdd Device dialog box Basic for IP version only MLC 104 IPAdd Device dialog box Advanced for IP version only Software Setup, cont’dGlobal Configurator Front Panel window Email Manager dialog box Defining e-mail server settingsSetting up e-mail notifications Add a Serial or IR Device MLC 104 series port configurationAdding e-mail contacts Downloading additional driversAdd IR Driver window Add Serial Driver windowConfiguring an input button Software Setup, cont’d Configure the Front Panel ButtonsConfiguring the On and Off buttons Front Panel window with configured buttonsDisplay shutdown action selection dialog Software Setup, cont’d Create a Display Shutdown ScheduleScheduled Actions Wizard Monitored Conditions Wizard dialog Conditions dialog. The Monitored Conditions WizardUnder the Available Options window Available Options windowBuilding a configuration Build and Upload a ConfigurationCreate a Display Disconnection E-mail IP model only Display lamp hour e-mail notificationAccessing GlobalViewer Uploading a configurationUpload Manager window before file upload GlobalViewer main
Related manuals
Manual 23 pages 31.53 Kb