Extron electronic MC104 IP Uploading a configuration, Accessing GlobalViewer, GlobalViewer main

Page 23

Software Setup, cont’d

Uploading a configuration

The process of uploading your project is essential to successfully configuring the MLC 104 and creating a GlobalViewer Web page for the MLC 104 IP. You can upload the project to one MLC at a time or several at once.

NYou can configure devices offline, but the device must be connected to the network for a successful upload.

The Upload Manager appears only after a build has been successfully performed on at least one device. If errors occur during the build of any devices, a dialog box appears listing the errors.

The Upload Manager window before file upload

To begin the upload, do the following:

1. Click Begin. The Upload Manger monitors the progress of the download.

2. Click Close.

The configuration should now be successfully uploaded to the appropriate product(s).

Accessing GlobalViewer®

After uploading a configuration file to a MLC 104 IP controller, there are two ways to access the GlobalViewer Web page:

•From the Upload Manager window, click the

Test GV System button.

•Right-click the MLC 104 IP controller icon in the IP Link tree and select Open GlobalViewer® Webpage.

GlobalViewer main page

3-22 MLC 104 Series MediaLink Controllers • Software Setup

MLC 104 Series MediaLink Controllers • Software Setup 3-23

Image 23

Contents MLC 104 and MLC 104 IP Series Precautions 安全须知中文 Table of Contents MLC 104 MediaLink Controllers Table of Contents, cont’dAbout the MLC 104 Medialink Controllers About Global ConfiguratorIntroduction About this ManualUpdating Firmware Installing the SoftwareIntroduction, cont’d System RequirementsTwo An MLC 104 series controller daisy chained to a SCP Hardware SetupRight Side Panel Features and Connections Power wiring Hardware Setup, cont’dButtons Left SideBaud Stop bit No parity Data bits No flow control Volume controlConfiguration host control port Pin out for TRS RS-232 cable wiringIP model only Software SetupDownload Device Drivers MLC 104 IP Software Setup, cont’d Create a New ProjectProject Settings dialog box Add Device dialog box Basic for IP version onlyAdd Device dialog box Advanced for IP version only Software Setup, cont’dGlobal Configurator Front Panel window Email Manager dialog box Defining e-mail server settingsSetting up e-mail notifications Downloading additional drivers MLC 104 series port configurationAdd a Serial or IR Device Adding e-mail contactsAdd IR Driver window Add Serial Driver windowFront Panel window with configured buttons Software Setup, cont’d Configure the Front Panel ButtonsConfiguring an input button Configuring the On and Off buttonsDisplay shutdown action selection dialog Software Setup, cont’d Create a Display Shutdown ScheduleScheduled Actions Wizard Available Options window Conditions dialog. The Monitored Conditions WizardMonitored Conditions Wizard dialog Under the Available Options windowDisplay lamp hour e-mail notification Build and Upload a ConfigurationBuilding a configuration Create a Display Disconnection E-mail IP model onlyGlobalViewer main Uploading a configurationAccessing GlobalViewer Upload Manager window before file upload