Host-to-MPS Communications
The MPS switcher accepts Simple Instruction Set (SIS) commands through the RS‑232 or USB configuration port. SIS commands consist of one or more characters per command field. They do not require special characters to begin or end the command character sequence. Each response to an SIS command ends with a carriage return and a line feed (CR/LF = ]), which signals the end of the response character string. A string is one or more characters.
MPS Switcher-initiated Messages
When a local event occurs, such as a front panel operation, the MPS switcher responds by sending a message to the host. The MPS
Boot-up messages
(c) Copyright 20 nn, Extron Electronics, MPS 601,
The copyright message is initiated by the switcher when it is first powered on. Vx.xx is the firmware version number.
Status change messages
The
MPS Switcher Error Responses
When the MPS switcher receives an SIS command and determines that it is valid, it performs the command and sends a response to the host device. If the switcher is unable to perform the command because the command is invalid or contains invalid parameters, it returns an error response to the host. The error response codes are:
E01 ] — Invalid input channel number (too large)
E06 ] — Invalid switch command (due to
E10 ] — Invalid command
E13 ] — Invalid parameter (out of range)
E14 ] — not valid for this configuration
E17 ] — Invalid command for signal type
E22 ] — busy
MPS 601 • Remote Communication and Control 21