Extron electronic MPS 601 manual Image Settings, Adding Edid to the Edid Library, Signal Sampling

Adding EDID to the EDID Library

1.Click Add EDID to Library. The Browse Add EDID to Library dialog box opens.

2.Navigate to the desired EDID file location and select it.

NOTE: Valid EDID files have a .bin file extension.

3.Click Open. The EDID is added to the Available EDID list.

Image Settings Page

From this page, signal sampling and picture control settings for the two analog inputs (inputs 1 and 2) are adjusted. Click the Image Settings icon on the Global Navigation Bar to open the Image Settings page.

Figure 30. Image Settings Page

Signal Sampling

To optimize signal sampling settings, select the analog input. Enter a value within the Min and Max values displayed to the right of each adjustable setting or click the Up or Down arrows.

NOTE: An asterisk beside a chosen value for a signal sampling setting indicates it is the default value for the applied video signal.

Horizontal Start – Defines the number of pixels from the start of the horizontal line where active video begins.

Vertical Start – Defines the number of lines from the start of the vertical line where active video begins.

Total Pixels – The total number of pixels in a horizontal line, including blanking on both sides of the active video area (active video, horizontal sync width, back porch, and front porch). The default value is determined by the source input. Values are adjusted from the default value by ±255.

Pixel Phase – The timing of digital sampling by the scaler. Sampling at the optimum pixel phase results in a bright, stable output and maximizes the contrast between pixels. A good image for phase adjustment has adjacent black and white pixels.

MPS 601 • Software Configuration and Control 38