
Installation
1U Universal Rack Shelf
1/2 Rack Width Front False
Faceplate
1/4 Rack Width Front False
Faceplate
Furniture mounting — under-desk
To mount the line driver under furniture, use the optional VersaTools
Both front false faceplates use 2 screws.
Use 2 mounting holes on opposite corners.
(2)
Preparing the line driver for
Mounting the line driver on a standard rack shelf
6" Deep Rack Shelf | 1/2 Rack Width Front False |
| Faceplate |
Front false faceplate uses 2 screws.
(2)
Use 2 mounting holes on opposite corners.
Mounting the line driver on a 6-inch rack shelf
1. If rubber feet were previously attached to the bottom of the unit, remove them.
2. Attach the mounting brackets to the line driver with the provided machine screws as shown in the previous figure.
3. Hold the unit with the attached brackets against the underside of the table or other furniture. On the mounting surface, mark the location of the bracket’s screw holes.
4. Drill ³⁄³²" (2 mm) diameter pilot holes, ¼" (6.3 mm) deep in
the mounting surface at the marked screw locations.
5. Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until slightly less than ¼" of the screw head protrudes.
6. Align the mounting screws with the slots in the brackets and place the unit against the surface, with the screws through the bracket slots.
7. Slide the unit slightly forward or back, then tighten all four screws to secure it in place.
8. Attach input and output cables. See chapter 3.
Furniture mounting — through-desk (CVEQ 100 only)
To mount the CVEQ 100 through furniture, use the optional VersaTools
CVEQ 100 and SVEQ 100 Series • Installation | CVEQ 100 and SVEQ 100 Series • Installation |