Quick Start
When using long cables, follow these steps:
a. Supply the color bars test signal to the input. (Recommendation: use an Extron VTG 300 Video Test Generator to generate the test signal.)
b. Adjust the Gain control(s) for the output until the signal level at the far end is the same as the input (or the display shows the correct brightness and contrast).
c. Adjust the EQ control for the output so that no overshoot or round front corner appears at the far end on the oscilloscope or you see a sharp picture with no smearing.
Step 7
See "Installation Instructions" in chapter 2 for further installation details.
Table of Contents
Chapter One • Introduction | |
About this Manual | |
Features | |
Chapter Two • Installation | |
Application Examples | |
Installation Instructions | |
Installing the CVEQ 100/SVEQ 100 | |
Mounting the CVEQ 100 and SVEQ 100 | |
Tabletop use | |
UL rack mounting guidelines | |
Rack mounting | |
Furniture mounting — | |
Furniture mounting — | |
Back of the rack mounting (SVEQ 100 only) | |
Installing the CVEQ 100 AAP/SVEQ 100 AAP | |
Installing the CVEQ 100 MAAP/SVEQ 100 MAAP | |
Mounting in an external wall box | |
Mounting in a European cable channel | |
Installing the CVEQ 100 D/SVEQ 100 D | |
Preparing the site and installing the wall box | |
Mounting the line driver | |
Testing and troubleshooting | |
If the image does not appear or there is no sound | |
If the image is not displayed correctly | |
Chapter Three • Operation | |
Front Panel Features and Operation | |
Rear Panel Features and Operation | |
Power supply wiring | |
Gain adjustment control | |
Equalization (EQ) adjustment control | |
Replacing the Decora Faceplate (CVEQ 100 D and |
|
SVEQ 100 D) | |
Appendix A • Specifications, Part Numbers, and |
|
Accessories | |
Specifications | |
Included Parts | |
Optional Accessories |
CVEQ 100 and SVEQ 100 Series • Table of Contents |