Gigabyte 8S648FXP-RZ-C user manual Password Check, CPU Hyper-Threading, Limit Cpuid Max. to

Page 24

English

Password Check

System

The system can not boot and can not access to Setup page will be denied if the

 

correct password is not entered at the prompt.

Setup

The system will boot, but access to Setup will be denied if the correct password

 

is not entered at the prompt. (Default value)

CPU Hyper-Threading

Enabled

Enables CPU Hyper Threading Feature. Please note that this feature is only working

 

for operating system with multi processors mode supported. (Default value)

Disabled

Disables CPU Hyper Threading.

Limit CPUID Max. to 3

Enabled

Limit CPUID Maximum value to 3 when use older OS lide NT4. (Default value)

Disabled

Disables CPUID Limit for Windows XP.

Init Display First

Select the first initation of monitor or display from AGP or PCI VGA card.

AGP

Set Init display first to AGP. (Default value)

PCI

Set Init display first to PCI.

8S648FXP-RZ Series Motherboard

- 24 -

Image 24
Contents 8S648FXP-RZ / 8S648FXP-RZ-C Motherboard 8S648FXP-RZ Installing the motherboard to the chassis Preparing Your ComputerTable of Contents Features Summary Introduction8S648FXP-RZ Series Motherboard Layout Cdin P4 TitanBlock Diagram Hardware Installation Process Install the Central Processing Unit CPUStep CPU Installation Install Memory Modules Install AGP Card Install I/O Peripherals CablesCdin FUSB1 / FUSB215 IR 17 BATATX12V / ATX Power Connector Cpufan / Sysfan Cooler Fan Power ConnectorFDD FDD Connector IDE1 / IDE2 IDE1 / IDE2 ConnectorSATA0 / SATA1 Serial ATA Connector Fpanel 2 x 10 pins Connector Faudio Front Audio Connector Spdifio Spdif In/Out ConnectorSurcen Surround Center Connector Cdin CD In ConnectorFUSB1 / FUSB2 Front USB Connector BAT Battery Clrcmos Clear CmosMain Menu For example Bios Ver. E10 Status Page Setup Menu / Option Page Setup MenuMain Menu Advanced Bios Features Power Management SetupPnP/PCI Configuration Load Fail-Safe DefaultsStandard Cmos Features DateTime IDE Channel 0 Master, Slave / IDE Channel 1 Master, SlaveFloppy 3 Mode Support for Japan Area Drive a / Drive BHalt on MemoryAdvanced Bios Features Hard Disk Boot PriorityFirst / Second / Third Boot Device Boot Up Floppy SeekPassword Check CPU Hyper-ThreadingLimit Cpuid Max. to Init Display FirstIntegrated Peripherals SiS Serial ATA Mode Parallel Port ModeECP Mode Use DMA USB ControllerPower Management Setup Power On by Keyboard Power On by MouseResume by Alarm Power LED in S1 statePnP/PCI Configurations PCI 4 IRQ AssignmentPCI 1/PCI 5 IRQ Assignment PCI 2 IRQ AssignmentCurrent CPU Temperature PC Health StatusCurrent Voltage V Vcore / DDR2.5V / +3.3V / +12V Current CPU/SYSTEM FAN Speed RPMMB Intelligent TweakerM.I.T Top Performance Load Fail-Safe Defaults Load Optimized DefaultsSet Supervisor/User Password ConfigurationsEnter PasswordSave & Exit Setup Exit Without SavingEnglish Install Drivers Pictures below are shown in Windows XPItem Description Contact Us Taiwan HeadquartersChina Shanghai